Loading ...
Loading ...
Loading ...
4. INSTALLATION INSTRUCTIONS
Tools Req
uired
A phillips screwdriver, a small flat head screwdriver,
a plier will be needed.
Locating the Appliance
Your new electric fireplace may be installed virtually
anywhere in your home. However, when choosing a
loction, ensure tha
t the gener
al instrutions f
or
safety are followed.
For best results, install out of direct sunlight , water or very
damp air.
Power supply service must be installed within proximity of electric fireplace prior to finishing
avoiding
reconstrucon.
Try to avoid any conditions that may cause the fireplace to vibrate, which would result in the
automatically turning on or off of the fireplace itself.
Due to many different finish materials use on walls, it is highly recommended that you consult
your
local builder before you install this fireplace in the wall.
•
•
•
•
Minimum Clearance to Combustibles
Sides............................0 inch
Floor............................0 inch
Back.............................0 inch
Top (Mantel or TV)......8 inch min
Front..........................36 inch
WARNING! Risk of Fire!
Keep electrical cords, drapery, furnishings or
other combustibles at least 3. (0.9 m) from
the front of the electric fireplace.
Electrical Supply Circuit Requirements
Plan the location of the appliance so that it will have adequate electric power. A 15 AMP, 120V/60Hz
circuit is required. Additional appliances on the same circuit as this appliance may exceed the current
rating of that circuit. A dedicated circuit is not required, but is preferred to prevent circuit breaker
trips or fuse failure.
Prepare the outlet close to the right side of appliance. Make sure the outlet is in good condition
and the plug must be plugged tightly in the outlet.
For hard wiring, please refer to page 11 to 12
6
Grounding Pin
Adapter
Metal Grounding
Screw
Loading ...
Loading ...
Loading ...