Loading ...
Loading ...
Loading ...
5
2. INSTALLATION
2.1 Loca n
When ng a posi on for your refrigerator, you should make sure the floor is flat and firm,
and the room is well ven
lated with an average room temperature between 50°F (10°C) and
109.4°F (43°C). Avoid placing your unit near a heat source, e.g. stove, heater or radiator. Also
avoid direct sunlight as it may increase the electrical consump on. Extreme cold ambient
temperatures may also cause the unit not to perform properly. This unit is not designed for use in
a garage or outdoor installa
Do not drape the unit with any
covering.
When installing the unit, ensure that 8" (20cm) of free space is le
at both sides, 6" (15cm) at the
rear and 8" (20cm) at the top of the unit. This will allow cold air to circulate around the
refrigerator and improve the efficiency of the cooling process. The door can be opened to the
right or the le , depending on what best suits the loca on. Please ensure there is adequate
space for the door to fully open.
2.2 Door Handle Install Illuminaon
Note: Figures in the user manual are only for reference. The actual product may differ slightly.
The refrigerator must be disconnected from the source of electrical supply before aempng the
installaon of accessory.
① Take out the two crisscross-screw;and install them into the door holes;
turn the screws ll to the boom;
② Aim at screws to install the handle;
③ The screws in the hole at the side of the handle and turn the screws ll them very ght;
④ Screw cap should be put on the screw.
(Pictures and objects are not consistent, in order to prevail in kind)
①
①
②
②
③
the hole
③
④
④
Loading ...
Loading ...
Loading ...