Loading ...
Loading ...
Loading ...
Note: Always set start time before setting the stop time.
5. Set the desired ambient room temperature (thermostat setting) with
and confirm with the enter button .
6. Set the heat setting between (fan only) / LOW HEAT/ MEDIUM
HEAT and HIGH HEAT with the buttons and confirm with the
enter button .
7. All settings for the first program are now done. Enter a new program
according to the steps 1-6 or activate the already entered program by
leaving this menu with the button.
8. In order to continuously run the entered program the cursor must be
positioned under the PROG symbol. The heater will operate according
to the entered information. When a program is running, the program
number will appear with the pre-set and ambient temperatures
alternating.
9. An entered program can be checked, edited or deleted just by navigating
into the PROG menu and pressing the enter button. With the
buttons the different program numbers can be selected. When a
program number is selected (flashing) the start/stop time will alternate
according to any pre-entered information. To delete one program
number, press the button. The CP symbol (clear program) appears
and by pressing the enter button this program will be deleted.
leaves the menu without deleting the program.
Time setting (TIME) - see Fig. 9.
Navigate the cursor to TIME with the buttons. Press the enter
button to adjust the weekday with the buttons. Confirm with the
enter button and set the hours and minutes with . Press the enter
button or to leave the time menu.
Frost protection - see Fig. 4.
Choose a heat setting and set the desired ambient temperature between
5°C and 8°C (see ‘Operation’).
When the temperature falls below +5 °C…+8 °C, the heater switches on
automatically.
Cleaning
WARNING : ALWAYS DISCONNECT FROM THE POWER SUPPLY
BEFORE CLEANING THE HEATER
Do not use detergents, abrasive cleaning powders or polish of any kind
on the Controller.
Wipe with a dry cloth to remove dust and a damp cloth (not wet) to clean
off stains. Be careful not to allow moisture into the Controller.
Use a vacuum cleaner to remove any fluff which accumulates on top of
the Controller.
Care must be taken to avoid any moisture ingress into the product.
Recycling
For electrical products sold within the European Community.
At the end of the electrical products useful life it should not
be disposed of with household waste. Please recycle
where facilities exist. Check with your Local Authority or
retailer for recycling advice in your country.
After Sales Service
Your product is guaranteed for one year from the date of purchase.
Within this period, we undertake to repair or exchange this product free
of charge (excluding element & subject to availability) provided it has
been installed and operated in accordance with these instructions.
Your rights under this guarantee are additional to your statutory rights,
which in turn are not affected by this guarantee.
Should you require after sales information or assistance with this product
please go to www.dimplex.co.uk where you will find our self help
guide by clicking on “After Sales” or ring our helpdesk on 0845 600
5111 (UK) or 01 842 4833 (R.O.I.) .
Spare parts are also available on the website
www.dimplex.co.uk
Please retain your receipt as proof of purchase.
www.dimplex.co.uk
Republic of Ireland Tel. 01 8424833
Dimplex UK Ltd.
Millbrook House
Grange Drive
Hedge End
Southampton
Hampshire. SO30 2DF
[c] Dimplex UK Limited
All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Dimplex UK Limited.