Loading ...
Loading ...
Loading ...
EN
W415-1542 / C / 01.13.16
16
4.0 FINISHING
!
WARNING
POWER SUPPLY SERVICE MUST BE COMPLETED PRIOR TO FINISHING TO AVOID
RECONSTRUCTION.
HEAT VENTS AND AIR OPENINGS CANNOT BE COVERED IN ANY CIRCUMSTANCES.
4.1 FRONT GLASS INSTALLATION
!
WARNING
BEFORE THE FRONT GLASS IS INSTALLED OR REMOVED UNPLUG THE APPLIANCE AND WAIT
UNTIL APPLIANCE IS COOL TO THE TOUCH. GLASS CAN BE HEAVY AND FRAGILE SO HANDLE
WITH CARE.
75.1
FOR MODELS NEFL50/60/72/100FH ONLY:
A. Before installing the front glass, remove the screws securing the paper board on the inside of the
appliance that protects the control panel. Discard the paper board.
B. Reinstall the screws,see Figure 1. (For recessed installed appliances only)
C. Remove the 2 screws from the top of the appliance.
D. Have two people, lift the glass up and away from the appliance, holding the glass vertical not fl at while
carrying. Place the glass face down onto a soft, non-abrasive surface, careful not to fl ex the glass.
E. Bend the top tabs fl at, see Figure 2
F. Install the crystal embers, refer to "CRYSTAL EMBER INSTALLATION" section.
G. Install the front glass by aligning with the pins on the appliance. Press the glass in and down to
securely engage with the brackets. It must be fully engaged to ensure the touch display panel
performs properly.
H. Secure the front glass using the screws provided to the top of the appliance, see Figure 3.(If fully
recessed this is not necessary)
Paper
Paper
Pin
FIG. 1
FIG. 2
Loading ...
Loading ...
Loading ...