Loading ...
Loading ...
Loading ...
13
15
15. Plug the Power Adapter (90) into the receptacle
on the frame of the elliptical.
Note: To plug the Power Adapter (90) into an
outlet, see HOW TO PLUG IN THE POWER
ADAPTER on page 14.
90
16. Make sure that all parts are properly tightened. Place a mat beneath the elliptical to protect the floor. Extra
parts may be included.
77
77
5
2
89
14
14. Untie and discard the wire tie attached to the
Main Wire (89).
While a second person holds the Console (5)
near the Upright (2), plug the Main Wire (89) and
the Pulse Wires (23) into the receptacles on the
Console.
The connectors on the Main Wire (89) and the
Pulse Wires (23) should slide easily into the
receptacles and snap into place. If a connector
does not slide easily into a receptacle, turn the
connector and try again. If you do not connect
the connectors properly, the Console (5) may
become damaged when you use the elliptical.
Insert the excess wire into the Upright (2).
Tip: Avoid pinching the wires. Attach
the Console (5) to the Upright (2) with four
M4 x 12mm Screws (77); start all the Screws,
and then tighten them.
Avoid pinching
the wires
23
Loading ...
Loading ...
Loading ...