Loading ...
Loading ...
Loading ...
Figure 5
Setting Operating
Frequency of SW605
Wall Control
Your wall control has code switches which
must be set in one of 32 possible code
combinations (Figure 5). The five levers
(numbered 1, 2, 3, 4, and 5) on the
switches are factory-set in the ON (up)
position. Change the switch settings as
follows:
1. Slide the five switch levers in the wall
control to your choice of ON (up) or
down positions. Use a ball-point pen or
small screwdriver and slide the levers
firmly up or down.
2. When power is restored after
installation of the wall control, push and
hold the fan OFF button ( ) for
3 to 5 seconds to set the code in the
receiver.
3. The sixth switch marked ON and I is for
dimming control of lights: Set switch to
ON to allow for dimming of the lights.
Set switch to I for no dimming of the
lights such as for fluorescent bulbs.
WALL CONTROL
CODE SWITCHES
ON
1
23
4
5I
CODE
SWITCHES
WALL
CONTROL
6
Setting Operating
Frequency of SR650
Remote Control
6. The sixth switch marked ON and I is for
dimming control of lights: Set switch to
ON to allow for dimming of the lights.
Set switch to I for no dimming of the
lights such as for fluorescent bulbs.
Your remote control has code switches
which must be set in one of 32 possible
code combinations. The five levers
(numbered 1, 2, 3, 4, and 5) on the
switches are factory-set in the ON (up)
position. Change the switch settings as
follows:
1. Slide the five switch levers in the
remote control to your choice of ON
(up) or down positions. Use a ball-point
pen or small screwdriver and slide the
levers firmly up or down.
2. When power is restored, push and hold
the fan OFF button ( ) for 3 to 5
seconds to set the code in the receiver.
3. If airflow is desired in the opposite
direction, press the ( ) button on the
wall control. The fan must be operating
at any speed for the reverse button to
function. The blades will turn in the
opposite direction and reverse the
airflow.
4. To set the desired fan speed, press the
( ) button to decrease the speed and
the ( ) to increase the speed. The
LED display will light up to indicate the
new speed selected.
5. To set the light intensity, press and
release the LIGHT ( ) button to
decrease the light intensity and the
LIGHT ( ) button to increase the light
intensity. The light will turn on at the
light intensity previously selected.
BP7417 SR600 SR650 SW605 12/15/09 8:29 PM Page 6
Loading ...
Loading ...
Loading ...