Loading ...
Loading ...
Loading ...
4
INSTALLATION
Tools required (not provided):
Pencil
Hammer
Level
Screw Driver
Power Drill and drill bits
A wall/ceiling mounting bracket is provided with the heater which has been specifically designed
to allow this product to be fitted to a wall or ceiling. Before drilling the holders, confirm that the
wall is solid and that there are no hidden water pipes or electric wires.
CAUTION! The appliance must be installed on a solid surface. Do not install on flammable wall
coverings or on surfaces that can be discolored or damaged when subject to heat.
Important: Ensure that the supply cable does not come into contact with reflector or hot surfaces.
The supply cable can be fixed to the metal mounting bracket behind heater with plastic zip ties.
1. This heater should only be installed by a competent person. It is advised to use a qualified
electrician.
2. Always disconnect the heater from the electricity supply and allow it to cool before handling
or installing. Do not install the heater on a flammable surface.
3. For ceiling mounting, the lowest part of the heater must be located at or above a minimum
height of 8 ft. from ground level, so that the heater cannot be touched when in operation.
4. For wall mounting, the lowest part of the heater must be located at or above a minimum
height of 6 ft. from ground level.
5. For both wall and ceiling mounting, there must be a distance of 24” between the heater and
any adjacent walls or corners.
6. For safe operation, the heater must be installed or placed a minimum of 3 ft. from people and
activities and from materials such as wood, carton, cloth and other flammables.
7. Always keep the supply cord away from the body of the heater which will get hot during use.
8. If the heater is installed vertically or at an angle, insure that the electrical cable is at the lower
end of the heater.
9. Before drilling, ensure that there are no wires or water pipes in the area where the heater is to
be installed.
10. The heater must be installed on the mounting brackets provided. Fasten the brackets securely
to the mounting surface and then to the backside of the heater using the nuts and screws
supplied.
11. A weatherproof outlet with proper GFCI protection is required if the heater is ever used
outside or near water or any water source.
12. Adjust the heater angle by loosening the two bolts on the wall mounting bracket, and tighten
the bolts again when the desired angle is achieved.
13. When mounted to a wall or a ceiling, do not position the heater at an angle more than 0°
(straight) or 45° (angled). Never allow the unit to point directly at a wall surface or to point
back toward the heater brackets.
Loading ...
Loading ...
Loading ...