Loading ...
Loading ...
Loading ...
10
/ Installation requirements / Electrical connection
ELECTRICAL
A properly-grounded horizontally- mounted electri-
cal receptacle should be installed no higher than
3” (7.6 cm) above the fl oor, no less than 2” (5 cm)
and no more than 8” (20,3 cm) from the left side
(facing product).
Check all local code requirements.
Verify that power is disconnected from the electri-
cal box before proceeding.
If the electrical supply is located in the opening,
electrical connection must be made prior to pla-
cing the oven in the opening. If the electrical sup-
ply is in an adjacent cabinet, the electrical con-
nection can be made after placing the oven in the
opening.
The installation must comply with all applicable
electrical codes.
Locate the electrical supply fl ush with the back
wall and within the shaded area shown in the il-
lustrations on the following pages. For ease of in-
stallation, the electrical supply for the oven can be
placed in an adjacent cabinet within reach of the
conduit.
● A circuit breaker is recommended.
The electrical junction box may be located above,
below to the left or right of the unit within reach of
the power cord.
Placement within the opening may be require ad-
ditional cabinet depth.
Warrning!
ELECTRICAL SHOCK HAZARD
Disconnect electrical power at the circuit bre-
aker box or fuse box before installing the ap-
pliance.
Provide appropriate ground for the appliance.
Use copper conductors only.
Failure to follow these instructions could re-
sult in serious injury or death.
Warning!
Electrical grounding
This appliance is equipped with a 4 ft (1.2 m) fl exi-
ble metal cable with 4 wires ready for connection
to a dedicated 3 pole, 4 wires grounded power
supply.
Caution
Label all wires prior to disconnecting when
servicing controls. Wiring errors can cause
improper and dangerous operation.
Verify proper operation after servicing.
The appliance shall be connected to a single pha-
se electric line rated at 120/208Vac or 120/240Vac
and 60Hz frequency.
INSTALLATION REQUIREMENTS ELECTRICAL CONNECTION
Type Voltage Circuit rating Electrical
supply
30” FD 120/208V
120/240V
8800W 42A
11000W 48A
50A
50A
E
5"
127
4"
102
Loading ...
Loading ...
Loading ...