Loading ...
Loading ...
Loading ...
DISHWASHER / USER INSTRUCTIONS
11 / 46
EN
Installation
A
This appliance must be
earthed
If the fitted moulded plug is not
suitable for your socket, then the
plug should be cut off and an
appropriate plug fitted.
Destroy the old plug, which is cut
off as a plug with a bared cord
could cause a shock hazard if
inserted into a socket elsewhere
in the house.
The moulded plug on this
appliance incorporates a 13A
fuse. Should the fuse need to
be replaced an ASTA approved
BS1362 fuse of the same rating
must be used. Do not forget to
refit the fuse cover. In the event
of losing the fuse cover, the
plug must not be used until a
replacement fuse cover has been
fitted. Colour of the replacement
fuse cover must be the same
colour as that visible on the pin
face of the plug. Fuse covers
are available from any good
electrical store.
Fitting a different plug
As the colours of the wires in the mains
lead of this appliance may not correspond
with the coloured markings identifying the
terminals on your plug, proceed as follows:
1. Connect the green - yellow or green
(earth) wire to the terminal in the plug
marked ‘E’ or with the symbol or
coloured green and yellow or green.
2. Connect the blue (neutral) wire to the
terminal in the plug marked ‘N’ or
coloured black.
3. Connect the brown (live) wire to the
terminal in the plug marked ‘L’ or
coloured red.
With the alternative plugs a 13A fuse must
be fitted either in the plug or adaptor or
in the main fuse box. If in doubt contact a
qualified electrician.
Initial use
Before starting to use the product, make
sure that all preparations are made
in accordance with the instructions in
sections “Important safety instructions” and
“Installation”.
• Before using the product, fill the salt
reservoir with 1 litre of water, add salt
(see next page) and stir to dissolve.
Run the Dishwasher without dishes on a
short programme with a small amount
of detergent.
A
There might be a small amount
of water left in the product after
factory quality control tests. This
causes no harm to the product.
Loading ...
Loading ...
Loading ...