1. Home
  2. Bella
  3. Bella 14575 User Manual
  4. Page 4

Bella 14575 1.2L Butterfly Meadow Electric Ceramic Kettle

User Manual - Page 4

For 14575.

PDF File Manual, 13 pages, Read Online | Download pdf file

14575 photo
Loading ...
Loading ...
Loading ...
5 4
NOTES ON THE CORD
The provided short power-supply cord should be used to reduce the risk
resultingfrombecoming entangled in or tripping over a longer cord.
Do not use an extension cord with this product.
NOTES ON THE PLUG
This appliance has a grounded 3-prong plug. Connect to a properly grounded
outlet only. Do not attempt to modify the plug in any way.
PLASTICIZER WARNING
CAUTION: To prevent Plasticizers from migrating to the nish of the counter
top ortable top or other furniture, place NON-PLASTIC coasters or place mats
between theappliance and the nish of the counter top or table top. Failure
to do so may cause thenish to darken; permanent blemishes may occur or
stainscanappear.
ELECTRIC POWER
If the electrical circuit is overloaded with other appliances, your appliance may
notoperate properly. It should be operated on a separate electrical circuit from
other appliances.
Getting to Know Your Electric Ceramic Kettle
Product may vary slightly from illustration
Power Base
Electrical Connector
Handle
Lid
Cord Exit Slot
(not shown)
Ceramic Body
Spout
Figure 1
3 Prong Plug
(not shown)
Lighted ON/OFF Switch
Note: keep illustration
callouts aligned
Before Using for the First Time
1. Boil a kettle of water following the Operating Instructions described in this Instruction Manual.
2. Discard the boiled water. Your kettle is now ready for use.
Operating Instructions
CAUTION: Do not immerse power base, power cord, or plug in water or any other liquid.
1. Position the power base on a stable, level surface near an electrical outlet. Unwind the power cord
from the cord storage area located beneath the power base. Make sure the cord exits through the
cord exit slot on the side of the power base.
2. Check that the ON/OFF switch is in the OFF (up) position.
3. Remove the kettle from the power base. Remove the lid. Fill with fresh, cold water to the desired
level. Thekettle yields up to 5 cups (1.2 liters) of water. Add water but do not ll above the MAX
water level. Wipe excess water off the kettle.
CAUTION: Never add water above the MAX water level. This could cause boiling water to
splatterout.
NOTE: If the kettle is accidentally switched ON without sufcient water, a boil-dry protection device
willautomatically turn the unit OFF. (See Boil-Dry Protection explanation in this Instruction Manual).
4. Check to be sure the sealing ring is properly assembled onto the lid. Close the lid and press down
gently until it snaps into position to ensure it is fully closed. Otherwise the kettle may not turn OFF
after boiling.
CAUTION: To avoid the risk of splashing while pouring hot water, make sure the lid is securely
closed ontothe kettle before operation.
5. Place the kettle on the power base, taking care not to spill any water.
6. Plug the power cord into a 120V AC electrical outlet. Press the ON/OFF switch down to the ON
position. The lighted button will illuminate. Water will begin heating immediately.
7. When a rolling boil is reached, the lighted button will then turn off; the ON/OFF switch will lift (up)
automatically and the kettle will turn OFF.
NOTE: The kettle can be turned OFF any time during the heating process by lifting the ON/OFF
switch up.
WARNING: This appliance generates heat and escaping steam during use. Proper precautions must
be taken to prevent the risk of burns, res, or other injury to persons or damage to property. Keep
hands and face clear of the area above the kettle.
8. Grasp the handle and carefully lift the kettle from the power base beforepouring.
CAUTION: Always check that the ON/OFF switch is in the OFF (up) position before removing it from
thepower base.
CAUTION: To avoid a risk of splashing, make sure the lid is securely closed onto the kettle before
operating. Pour slowly and be careful to not over-tilt the kettle.
CAUTION: Do not touch hot surfaces!
9. To reheat, check the water level to ensure it is above the MIN water level. If necessary, add more
waterbefore returning the kettle to the powerbase.
10. Allow at least 30 seconds before pressing the ON/OFF switch down to the ON position.
11. When not in use unplug the power cord from the wall outlet. Allow the unit to cool completely
beforecleaning. Empty the kettle after each use. Do not allow water to sit in the kettle overnight.
SeeUserMaintenanceInstructions.
SO-313492_14575_BELLA_1.2L Ceramic Kettle butterfly_Macy's_IM_145x210_R2.indd 4-5 2016-05-27 9:23 AM
Loading ...
Loading ...
Loading ...