Loading ...
Loading ...
Loading ...
Important: Always switch off and remove the
plug from the electricity supply before cleaning
the condenser.
To maintain the efficiency of the dryer regularly
check that the condenser is clean.
OPERATION
1. Open the door and load the drum with
laundry. Ensure that garments do not hinder
closure of the door.
2. Gently close the door pushing it slowly until
you hear the door 'click' shut.
3. Turn the Programme Selector dial to select
the required drying programme (see
Programme Guide).
4. If drying synthetics, acrylics or delicate
items, press the button to reduce the
heat level.
The indicator will light up when the machine is
in low heat setting. To deselect in the first few
minutes of the programme, press the
button , after this time reset the machine to
change the setting.
5. Press the button. The dryer will start
automatically and the indicator above the
button will be continuously lit.
6. If the door is opened during the programme
to check the laundry, it is necessary to press
to recommence drying after the door has
been closed.
7. When the cycle is nearing completion the
machine will enter the cool down phase, the
clothes will be tumbled in cool air allowing the
load to cool down.
8. Following the completion of the cycle the
drum will rotate intermittently to minimize
creasing. This will continue until the machine
is switched OFF or the door is opened.
Do not open the door during the automatic
programs in order to obtain a proper drying.
To Remove the Condenser
1.Remove the kickplate.
2. Turn the two locking levers
anti-clockwise and pull out
the condenser.
3.Pull out the condenser unit.
4. Gently remove any dust or
fluff with a cloth, then wash
the unit by holding it under a
running tap turning it so that
water flows between the
plates, to remove any dust or
fluff.
5.Check the gasket position
after cleaning.Fit the gasket
in to the groove if it is
misaligned.
6.Refit the condenser ensuring it
is in the correct way (as indicated
by the arrow) and pushed firmly
into place. Lock the two levers by
turning them clockwise.Be sure
that condenser unit fixed to the
basement tightly.
7. Refit the kickplate.
CONDENSER
12 EN
Loading ...
Loading ...
Loading ...