Loading ...
Loading ...
Loading ...
DOOR and FILTER
WARNING! When the tumble dryer is in use
the drum and door may be VERY HOT. Never
stop a tumble dryer before the end of the drying
cycle unless all items are quickly removed and
spread out so that the heat is dissipated.
Filter Care Indicator
DO NOT USE WATER TO CLEAN THE FILTER.
IMPORTANT: To maintain the efficiency of the
dryer check that the fluff filter is clean before
each drying cycle.
1 . P u l l t h e f i l t e r
upwards.
2. Open filter as shown.
3. Gently remove lint
using a soft brush or
your fingertips.
4 . S n a p t h e f i l t e r
together and push
back into place.
WATER CONTAINER
The water removed from the laundry during the
drying cycle is collected in a container inside the
door of the dryer. When the container is full the
indicator on the control panel will light, and
the container MUST be emptied. However, we
recommend that the container is emptied after
each drying cycle.
NOTE: Very little water will collect during the
first few cycles of a new machine as an internal
reservoir is filled first.
Lights when the
filter needs cleaning.
If the laundry is not
drying check that the
filter is not clogged.
WARNING! If you open the door mid cycle,
before the cool-down cycle has completed,the
handle may be hot. Please use extreme caution
when attempting to empty the water reservoir
during the cycle.
Filter
11 EN
To restart the dryer, close the door and press
Start / Pause button.
Pull on handle to open the door.
To Remove the Container
1.G e n tly p u l l th e
bottom of the kickplate
so that it unclips from
the dryer. The top
section can then be
unhinged allowing the
k i c k p l a t e t o b e
completely removed.
2.Pull firmly on the
handgrip and slide the
water container out of
the dryer
.
Support the container
with both hands. When
f u l l , t h e w a t e r
container will weigh
about 4kg.
3. Open the lid located
on the top of the
container and empty
the water.
4. Refit the lid and slide
the water container
back into position.
PUSH FIRMLY INTO
PLACE.
5. Refit the kickplate
b y e n g a g i n g t h e
hinges at the top and
'snapping' the lower
clips into place.
Loading ...
Loading ...
Loading ...