Loading ...
Loading ...
Loading ...
Maintenance
Lubrication
All moving parts are sealed in a permanent supply of lubricant or
are equipped with oilless bearings. Additional lubrication will not be
necessary.
Care of Your Dryer
WARNING
To reduce the risk of an electric shock, serious injury
or death, disconnect the electrical service to the dryer
before cleaning the interior.
W132
Dryer Interior
Wipe the surfaces using a soft cloth and household cleaner or a
non-abrasive paste of powdered laundry detergent and hot water,
followed by a short heat cycle with a load of rags.
To remove crayon or ball point ink off the dryer drum, put the heat
on high and use old rags in the dryer to absorb the crayon or ink. If
unsuccessful, contact the appliance dealer. DO NOT use any chemi-
cals in the dryer.
IMPORTANT: The use of chlorine bleach for removing
any discolorations should be avoided because bleach
could damage the finish.
Cabinet
Wipe the dryer cabinet as needed. If detergent, bleach or other
washing products have been spilled on the dryer, wipe immediately.
Some products will cause permanent damage if spilled on the cabi-
net.
Control Panel
Use only a damp or sudsy cloth for cleaning the control panel. Some
spray pretreat products may harm the finish on the control panel.
DO NOT use products that contain alcohol on the control panel.
Exhaust System
WARNING
To reduce the risk of electric shock, disconnect the
electrical service to the dryer before cleaning.
W043
WARNING
Any disassembly requiring the use of tools must be
performed by a suitably qualified service person.
W299
The exhaust duct should be inspected after one year of use and
cleaned if necessary by a qualified service person to remove any lint
build-up. Inspect and clean exhaust duct every one to two years as
required thereafter.
Every two years a qualified service person should remove all front
panels and vacuum the inside of the dryer
NOTE: This recommended maintenance is not covered
under the terms of the warranty.
The weather hood should be checked frequently to make sure the
dampers move freely, dampers are not pushed in and that nothing
has been set against them.
Keep dryer area clear and free from combustible materials, gasoline
and other flammable vapors and liquids.
Do not obstruct the flow of combustion and ventilation air.
NOTE: Verify proper operation after servicing.
Motor Overload Protector
The dryer’s motor overload protector stops the motor automati-
cally in the event of an overload. The control’s digital display will
show “Er”, “ro” alternately. After cooling, the overload protector will
reset itself.
The control can be cleared by pressing START and the dryer can be
restarted by pressing START again. If overload protector cycles
again, remove the dryer from use and call the service person to cor-
rect the problem.
Maintenance
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
13 Part No. D514472ENR4
Loading ...
Loading ...
Loading ...