Loading ...
Loading ...
Loading ...
8 9INSTALLATION
The appliance must not be installed in a corner. It
must be installed at least 100mm from the side wall.
100mm
WARNING
WARNING
Step 3: Stability bolt
1. Remove oven door – to be done by qualified
personnel only. For separate grill models only.
(Refer to procedure).
2. Remove screws from kick panel. To remove kick panel
lift kick panel upwards to release the two Location
Tabs from the holes in the bottom of the panel.
3. Position the cooker into the anti-tilt bracket.
4. Remove the tape from the stability bolt.
5. Rotate the stability bolt 180˚ clockwise until it is
pointing to the left like the picture below.
6. The stability bolt should now be able to drop to
the floor.
7. Mark the position for the stability bolt on the floor.
8. Pull the cooker out and drill the bolt hole, using a
6.5mm masonry or wood drill. Minimum 30mm deep
for concrete.
9. Reposition the cooker back into place, then fit the
stability bolt into the drilled hole.
Stability
bolt
Kick panel
ø6.5mm drilled
location hole
Front
adjustable feet
TIPS & INFORMATION
IMPORTANT
Setting the time
If you have purchased a model fitted with an electronic
or programmable clock, you MUST set the time of day
before you can operate your appliance.
WARNING
WARNING
Fitting oven shelves
1. Ensure shelf orientation is correct (refer to
diagram below).
2. Slide oven shelves onto oven supports (side runners)
at an angle until raised back of shelf is past the stop
on oven supports (side runners).
3. Lower front of shelf and push in until stop is reached.
4. To remove oven shelves, withdraw to the stop and
raise the front of shelf to clear the stop.
Note the orientation of the
side and rear features
Not a shelf
position
5 shelf positions
1
2
3
4
5
NOTE: The top ledge is not a shelf position. There are no
stops for shelf withdrawal.
INSTALLATION
WARNING
CAUTION
5mm clearance min.
5mm clearance min.
596mm
Installation dimensions
WARNING
WARNING
Installers responsibility
In ALL cases the anti-tilt bracket MUST be securely
anchored to the floor with suitable fasteners, and the
stability bolt fixed.
The anti-tilt bracket is a mandatory safety restraint.
In order to prevent accidental tipping of the appliance;
for example by a child climbing onto the open door,
the anti-tilt bracket supplied with the cooker MUST be
installed. ALWAYS ensure that the cooker is located so
that the anti-tilt bracket is engaged into the cooker.
The unit must be pushed up against the wall on
installation. On gas units check that the gas hose,
if used, has not been kinked during installation.
Following table outlines the distance between the floor
supporting cooking vessel:
Surface type
(Supporting vessel)
Distance (mm)
Coil 925
Ceramic 913
INSTALLATION
Step 1: Positioning
Choose the most practical bracket mounting option for
your cooker. The anti-tilt bracket can be floor mounted or
floor and skirting mounted depending on the location of
the range plug/socket/connection.
AA
Detail A
3 Fasteners
Minimum
3 fasteners
Detail A
Step 2: Fixing anti-tilt bracket
Position the anti-tilt bracket so that it will fully engage
into the slot at the rear of the cooker. The bracket is
mounted centrally at the rear of the cooker. Anchor the
bracket into position using appropriate fasteners.
Wall
Loading ...
Loading ...
Loading ...