Loading ...
Loading ...
Loading ...
PROGRAMMING YOUR BREWER
NOTE: You must set the clock to use the Auto-Start function. Remember to reset the clock
for time changes and power outages.
set clock
auto-start
(
optional
)
1. Plug power cord into standard
electrical outlet.
2. Display will flash for 10 seconds before
setting automatically. (If not set, 12:00
AM becomes default time.)
3. Set time using H (hour) and M (minute)
buttons.
4. Numbers scroll forward only.
5. Take care to select correct AM/PM time.
6. Press Clock button again to lock in time.
1. Press Auto-Start button. H (hour) and
M (minute) buttons will light up, time
will flash on digital display.
2. Set time using H (hour) and M (minute)
buttons. Numbers scroll forward only.
Stop at desired Auto-Start time. Take
care to select correct AM/PM time.
3. When desired time is on the digital
display, press Auto Start button to
activate. It will be set and Auto-Start
will activate or wait 10 seconds and it
will set automatically. Once activated,
Auto-Start button will illuminate white.
4. To cancel a programmed Auto-Start,
press the Auto-Start button until Auto
Start button is not lit.
5. Place BUNN coffee filter and coffee
grounds into the Brew Funnel and slide
into the Funnel Guides.
6. Fill brewer with 20 – 50oz of water and
place Carafe on base of brewer (failure
to follow steps 5 and 6 may result in
property damage).
3
NOTE: The Auto-Start function must be activated each time you want to schedule a brew.
If the Auto-Start button is not illuminated, the Auto-Start function is not activated.
NOTE: To check your Auto-Start setting at idle, press the Auto-Start button twice and the
digital display will flash the programmed time. The flashing time will remain the set time
unless you change it. After 10 seconds with no buttons pushed, the Auto-Start button will
illuminate and Auto-Start is set. To cancel, press Auto Start again.
Loading ...
Loading ...
Loading ...