Loading ...
Loading ...
Loading ...
en Operating modes
10
6.5 Residual heat indicator
The hob has a residual heat indicator for each cooking
zone. This indicates that a cooking zone is still hot. Do
not touch the cooking zone immediately after switching
it off or while the residual heat indicator is lit.
Depending on the amount of residual heat, the
following is shown:
¡ display: High temperature
¡ display: Low temperature
If you remove the cookware from the cooking zone dur-
ing cooking, the residual heat indicator and the selec-
ted power level flash alternately.
If you switch off the cooking zone, the residual heat in-
dicator lights up. If the hob has been switched off, the
residual heat indicator remains lit for as long as the
cooking zone remains warm.
7 Operating modes
You can use your appliance in air extraction mode or
circulating-air mode.
The saturation indicator must be adjusted to the selec-
ted operating mode and the filters used.
7.1 Air extraction mode
The air which is drawn in is cleaned by the grease fil-
ters and conveyed to the exterior by a pipe system.
The air must not be discharged into a
flue that is used for exhausting fumes
from appliances burning gas or other
fuels (not applicable to appliances that
only discharge the air back into the
room).
¡ If the exhaust air is to be conveyed
into a non-functioning smoke or ex-
haust gas flue, you must obtain the
consent of the heating engineer re-
sponsible.
¡ If the exhaust air is conveyed
through the external wall, a tele-
scopic duct should be used.
7.2 Air recirculation mode
The air which is drawn in is cleaned by the grease fil-
ters and an odour filter, and conveyed back into the
room.
To bind odours in circulating-air mode,
you must install an odour filter. The dif-
ferent options for operating the appli-
ance in circulating-air mode can be
found in our catalogue. Alternatively,
ask your dealer. The required accessor-
ies are available from specialist retail-
ers, from customer service or from the
Online Shop.
8 Before using for the first time
Configure the settings for initial start-up. Clean the ap-
pliance and accessories.
8.1 Setting the operating mode
The appliance is supplied with a preset circulating-air
mode.
When your hob is installed with an air outlet to the out-
side, you must configure the setting to this mode.
You can find additional information about this in the
section entitled
→"Basic settings", Page15
9 Basic operation
You can find out everything you need to know about
operating your appliance here.
9.1 Switching the hob on and off
Switch the hob on and off using the main switch .
If you switch the appliance back on again within
fourseconds after switching off, the hob starts up with
the previously stored settings.
Note:Never operate the appliance without the metal
grease filter and the overflow container.
Switching on the hob
▶
Touch .
An audible signal sounds and the display beside
it lights up.
a The hob is ready for use.
Loading ...
Loading ...
Loading ...