Factory Restart:
1. Remove all power (batteries and AC) from outdoor sensor and weather
station.
2. Press one of the buttons on the weather station at least 20 times to clear
all memory.
3. Verify that the weather station is blank before proceeding (there may be
lines painted on
the screen that will show when there is no power).
4. Leave both units without power for 15 minutes (very important).
5. Insert the AC power cord into the wall outlet then into the weather
station.
6. Insert fresh batteries into the outdoor sensor.
7. Press the TX button on the outdoor sensor to transmit RF signal.
8. Keep the outdoor sensor 5-10 feet from the weather station.
9. When RF connection is established, the temperature will appear on the
station. Allow the
outdoor sensor and weather station to sit together for 15 minutes to
establish a strong
connection.
10. Do not press buttons for 15 minutes.
For optimum 433MHz transmission, place the outdoor sensor no more than 300
feet (91
meters, open air) from the weather station
Tips on the Backlight
When operating with the power cable, the backlight is adjustable: HI-LOW-
OFF.
Press and release the BACKLIGHT button to adjust backlight.
When operating on batteries only, the backlight will come on briefly when
the
BACKLIGHT button is pressed.
Battery power: When operating on battery power only, press and release the
any button
and the backlight will show for 10 seconds.
Try this exercise in a dim room. The weather station has a bright, dim and
OFF setting for
the backlight. Wait 15 seconds after pressing the BACKLIGHT button to see if
backlight
stays on. This will assure it is not in OFF SET.
1. Check that the AC cord is inserted correctly to the weather station and
the outlet.
2. Remove the batteries.
3. Press the BACKLIGHT button. If the backlight comes on and the display is
active your
AC cord works.
4. Wait 15 seconds to see if the back light stays on.
5. If the backlight goes out after 15 seconds, repeat #3.
