Loading ...
Loading ...
Loading ...
W005I_SVG
2
1
1. Risers (Air cushions)
2. Water Supply Faucets
Figure 5
Connect Drain Hose to Drain
Receptacle
IMPORTANT: The drain hose installation is a very im-
portant factor in the washer installation. If care is not
taken when the drain hose is installed, a siphoning ac-
tion can be started which will cause water to be si-
phoned from the washer during the cycle.
Drain Facilities
End of drain hose should never be in water as siphoning action
can be started that will cause water to be siphoned back into the
washer.
The curved end of drain hose MUST be installed even with or
above the height of the cabinet top of the washer to prevent si-
phoning. Refer to Figure 6 .
TLW2251N_SVG
3
2
1
1. Drain Hose
2. Standpipe
3. Recommended Standpipe Height 36 in. [914 mm] Mini-
mum
Figure 6
The standpipe or drain receptacle must be capable of handling a
minimum of 1-1/2 inches [38 mm] outside diameter drain hose.
The drain hose should fit loose within the standpipe (it should not
be snug fit). Never install the drain hose into a “sealed” drain sys-
tem as air cannot escape and will restrict the water from being
drained from the washer. A sealed drain system may also allow
water to be pumped back into the washer during agitation. Both
of these conditions may result in flooding of the washer.
Remove the drain hose from its shipping position on the rear of
the washer by unhooking the hose from the retainer clamp.
If necessary, follow the instructions for your type of drain recep-
tacle (high standpipe or low standpipe) to properly install the
drain hose.
High Standpipe Installation
NOTE: No. 562P3 Siphon Break Kit and No. 25863 Hose
Coupling are not required for this type of installation.
Installation
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
15 Part No. 205161EN
Loading ...
Loading ...
Loading ...