Loading ...
Loading ...
Loading ...
2. Deadbolt Latch Installation (Piece B) 3. Strike Installation (Piece C)
With bolt retracted, insert deadbolt latch into
edge hole keeping flat edge of bolt parallel to
the edge of door. Be sure to keep the word
"UP" at top.
Using a wood block, tap with hammer until
surface of collar is flush with door edge
Re-extend bolt.
First-time Installation
Draw a horizontal centerline across the door
jamb, the same distance from floor as is the
centerline of deadbolt latch.
Measure back from door stop, 1/2 the
distance of the door thickness and draw a
vertical centerline. At crosspoint, drill a 1-1/8”
diameter (28.5mm) hole,1-1/4” (29mm) deep,
in the door jamb.
Center strike over hole and trace around
strike. Chisel out door frame until strike is
flush.
Position strike with large holes toward door
stop. Pre-drill large holes 3” (76mm) deep.
Important Note:
Deadbolt latch must enter strike
with no resistance or the Power-
bolt Touchpad Electronic Deadbolt
will not work properly.
1
2
1
2
3
U P
3
4
Door
Jamb
1/2 of door
thickness
Door
Stop
For Drive-In latch:
Install strike
Install 3” (76mm) screws in large strike holes
and install remaining 5/8” wood screws in
smaller holes.
Close door and ensure bolt extends and
retracts freely.
1
2
Loading ...
Loading ...
Loading ...