Loading ...
Loading ...
3
A Cut the BLACK wire that is connected to blower switch and light switch.
RED WIRE CONNECTION
MOTOR SWITCH
TERMINALS
LIGHT SWITCH
TERMINALS
MOTOR SWITCH
TERMINALS
LIGHT SWITCH
TERMINALS
BLACK WIRE
RED WIRE
FROM 14/3 CABLE
A
B
BLACK WIRE
A
B
MOTOR SWITCH
TERMINALS
LIGHT SWITCH
TERMINALS
MOTOR SWITCH
TERMINALS
LIGHT SWITCH
TERMINALS
RED WIRE
FROM 14/3 CABLE
ROCKER SWITCHES
BPDC1 SERIES
ELONGATED ROCKER SWITCHES
BPDP1 AND NPDP1 SERIES
B Cap off the BLACK wire connected to the light switch terminal. Connect the RED wire from 14/3 cable to the BLACK wire from the motor
switch, using an appropriate wire nut.
Once all the connections are done, finalize the installation by reversing steps
to on first page.
RANGE HOOD OPERATION
Use the hood control to set or change the blower and light intensities desired; these settings will be applied when using the wall
switches. For example, if the blower is set on high speed using the hood control, when the user presses on the motor rocker switch on
the wall control, the blower will then turn on high speed. If the user wants the blower to turn on low speed, the blower speed must be
changed using the hood control. It is not necessary to turn off the blower to change its speed.
The same procedure applies for the light intensities (when low and high intensities are available).
THIS PROCEDURE APPLIES TO BROAN BPDC1, BPDP1, AND NUTONE NPDP1
DOUBLE BLOWER RANGE HOOD SERIES.
Loading ...
Loading ...
Loading ...