Loading ...
Loading ...
Loading ...
Step 4
- In order to prevent the hood from unhooking owing to pressure from under-
neath, fasten it to the wall with a screw anchor and relevant screw inserted
in the appropriate hole (Fig. 4).
ASSEMBLY INSTRUCTIONS FOR
CORNER HOODS WITHOUT BAR
Step 1
- Undo the rear metric screw (A) and remove the motor from the bottom of
the hood (fig. 1).
- Check the horizontal alignment with a spirit level and mark the 4 holes to be drilled.
- Drill the holes, insert 2 x 8mm dia. screw anchors and fix the hood in the desired
position, using 2 screws B fixed in the two slots in the top back panel (Fig. 5).
- Fit the safety screws C in the bottom back panels (Fig. 5).
Step 2
- After having fixed the hood, connect the flexible hose to the fume outlet hole
and to the circular pipe fitting of the motor chamber.
- Replace the motor at the bottom of the hood and secure it with the rear
metric screw (A) (fig. 2).
MOUNTING THE RANGE HOOD
WITHOUT MOTOR CHAMBER
1) Measure the distance (L) from the bottom of the range hood to the centre of
the mounting holes (Fig. 7).
2) Measure the distance (M) between the two mounting holes.
3) Line up the centre of the cooktop with the centre of the range hood. Is: L+650
mm.
4) The height of the holes to be drilled above the cooktop is calculated by ad-
ding (L) to (H), where (H) is defined by point C-1.
5) Drill the holes for the Fischer screw anchors (the diameter of the holes de-
pends on the type of screw anchor).
6) Before hanging and securing the range hood, remove:
- the steel grilles for range hoods with tangential motors
- the entire build-in assembly, if fitted, by unscrewing the screws that secure
it to the bottom.
7) Hang the range hood.
8) Check, through the hole at the bottom, that the range hood is properly an-
chored to the Fischer hooks.
9) Adjust the height of the range hood using the screws on the Fischer hooks.
10) Fit the steel grilles or the build-in assembly.
11) Mounting instruction for chimney (fig. 8):
- Fasten bracket (A) to the wall, at the correct distance;
- Fasten the upper part of the extension to bracket (A).
25
Loading ...
Loading ...
Loading ...