Loading ...
Loading ...
Loading ...
sure the mains voltage corresponds to the values on the rating plate located
inside the range hood. The minimum safety distance between the cooktop and
the range hood must be at least 65 cm.
Never cook on “open” flames under the range hood.
Check deep-fryers during use: superheated oil may be flammable.
- Ensure there is adequate ventilation of the room when the rangehood is
used at the same time as appliances burning gas or other fuels.
- Do not flambe under the rangehood
-The exhaust air must not be discharged into a flue which is used for exhaust-
ing fumes from appliances burning gas or other fuels.
- Ensure that all regulations concerning the discharge of exhaust air have
been fulfilled before you use the appliance.
Before performing any cleaning or maintenance operations, disconnect the
appliance by unplugging it or using the main switch. The manufacturer dis-
claims all liability for any damage that may be directly or indirectly caused
to people, things and animals due to the failure to follow all the instructions
provided in this booklet and above all the warnings relating to the installa-
tion, operation and maintenance of the appliance.
N
O
WARRANTY
The new equipment is covered by warranty. The warranty conditions are pro-
vided by the distributor.
The manufacturer is not liable for any inaccuracies in this booklet resulting
from printing or transcription errors. The manufacturer reserves the right to
modify its products as it considers necessary or in the interests of the user,
without compromising their essential safety and operating characteristics.
ASSEMBLY INSTRUCTIONS FOR
WALL-MOUNTED RUSTIC HOOD
Step 1
- Rest the support batten (A-Fig. 1) against the wall at a height above the hob
determined by the sum of the values X+Y+265 mm.
- Use a spirit level to make sure it is perfectly horizontal and make 2 marks at
the ends of the batten where the 2 holes are to be drilled.
- Drill the holes, insert the two ø 8mm screw anchors and fasten the batten
using the relevant screws.
Step 2
- Hook the hood onto the support batten (Fig. 2).
Step 3
- Adjust the alignment of the hood using the screws on the brackets (Fig. 3).
The upper screw (B) is used to adjust the distance from the wall, and the
lower screw (C) the vertical sliding
24
Loading ...
Loading ...
Loading ...