Loading ...
Loading ...
Loading ...
13
EN
Hints on Boil Dry
This device has a preventive boil dry function, if the element overheats, the thermostat
will cut off the machine automatically. Operating the machine correctly is very important.
If the element does overheat, please just wait few minutes for it to cool down to reset
temperature.
CLEANING AND CARE
• The device must be cleaned immediately after the brewing process. Avoid surface
drying of wort and malt remnants, as this will signicantly impair the cleaning
process.
• All stainless steel components can be cleaned using a conventional detergent.
Abrasive agents and sponges/brushes that cause scratching are not suitable.
Ideally use a pipe cleaner thread to clean the bottom element part.
• When cleaning the brewing vessel ensure that no water spray or moisture comes
into contact with the electrical components. The Plug must be disconnected for
performing cleaning activities.
• Before starting the brewing process, remove all dust and dirt from the device and all
internal ttings by means of warm water.
• The valve also needs to be cleaned, all the components like water pipe, cover and
false bottom should be cleaned, as this could have a negative impact your brewing
results.
TROUBLESHOOTING
Problem Possible Cause and Solution
Element with burn marks. Use an ingredient bag during mashing.
Clean it with vinegar, Lemon juice and a soft cloth.
Switches off during boiling. Do not use 2500W for full power boiling, switch it
to 1600W.
Contact seller change a higher temperature limited
thermostat.
Loading ...
Loading ...
Loading ...