Loading ...
Loading ...
Loading ...
21
Headline
48” Custom Panels
21
General Information
Area Requirements
Verify the following:
• Unit can t into residence and can be
moved around corners and through
doorways.
• Floors can support unit’s weight plus
food weight (approximately 1200 pounds
[540 kg] per unit).
• Floors underneath refrigerator are level
with surrounding nished oor.
• Rear wall is solid and is able to support
two horizontally mounted 2 x 4s (included)
bolted to two wall studs. The 2 x 4 board
bolt heads must be ush with 2 x 4 to
prevent obstruction.
• Remove anything attached to rear or side
walls that can obstruct unit installation.
• Cutout dimensions are accurate.
• Electrical outlet is in correct location.
• Water line is in correct location.
• DO NOT install a refrigeration unit near
a heat source, nor in a location where the
surrounding temperature will fall below
60º F (16º C).
Electrical Requirements
It is the customer’s responsibility to:
• Contact a quali ed electrical installer.
• Assure that the electrical installation is
adequate and in conformance with
the National Electrical Code, ANSI/
NFPA 70-latest edition or Canadian
Electrical Code C22.1-1998 and C22.2
No. 0-M91 (or latest edition), and all local
codes and ordinances.
A 115 volt, 60-Hz, 15 amp, fused, electrical
supply is required. It is required that a separate
circuit serving only this appliance be provided.
This appliance is equipped with a power supply
cord having a 3-prong grounding plug. To
minimize possible shock hazard, the cord must
be plugged into a mating 3-prong, grounding-
type wall receptacle. DO NOT use an extension
cord.
If codes permit a separate grounding wire
to be used, it is recommended that a quali ed
electrician determine that the grounding path is
adequate.
DO NOT ground to a gas line. Check with a
quali ed electrician if you are not sure if the
appliance is properly grounded. DO NOT
have a fuse in the neutral or grounding circuit.
Anti-Tip Requirements
The anti-tip boards should be fastened
into position prior to moving the unit into
the opening.
Note: Additional mounting boards may
be required if the unit does not touch
the back wall of the enclosure. To prevent unit from
tipping forward, it must be secured in place with a
solid so t or wood block.
Loading ...
Loading ...
Loading ...