Loading ...
Loading ...
Loading ...
English | 27
Once the measuring tool has been switched on, the rear edge of the measuring tool is se-
lected as the reference level for measurement. To change the reference level (see "Se-
lecting the reference level (see figures A–B)", page27).
Place the measuring tool at the line you want to measure from (e.g. wall) with the refer-
ence level selected.
To initiate the measurement, briefly press the measuring button (4). Afterwards, the
laser beam is switched off. To switch the laser beam on again, briefly press the measur-
ing button (4). To initiate a further measurement, briefly press the measuring button (4)
again.
u Do not direct the laser beam at persons or animals and do not stare into the laser
beam yourself (even from a distance).
In the continuous measurement function, measurement will begin after the first press of
the measuring button (4).
The measured value typically appears within half a second and no later than four
seconds. The duration of the measurement depends on the distance, the lighting condi-
tions and the reflective properties of the target surface.
If no measurement has been performed within approx. 20seconds of aim being taken,
the laser beam is switched off automatically to preserve battery life.
Selecting the reference level (see figures A–B)
You can choose between two different reference levels for the measurement:
– The rear edge of the measuring tool (e.g. when placing against walls)
– The front edge of the measuring tool (e.g. when measuring from a table edge).
To change the reference level, press the button (6) until the required reference level is
shown on the display. The rear edge of the measuring tool is pre-set as the reference
level every time the measuring tool is switched on.
Measuring functions
Measuring length
For length measurements, repeatedly press the button (2) or press and hold the measur-
ing button (4) until the indicator for length measurement appears on the display (5).
29.589 m
6.111 m
30.000 m
Press the measuring button (4) once to aim at the target surface and
again to measure.
The measured value will be shown at the bottom of the display.
Repeat the above-mentioned steps for each subsequent measure-
ment. The last three measured values are shown on the display. The
Bosch Power Tools 1 609 92A 4P0 | (18.01.2019)
Loading ...
Loading ...
Loading ...