Loading ...
Loading ...
Loading ...
4
INSTALLATION INSTRUCTIONS - Gas Line
Open position
to appliance
from gas supply
Gas Connection
1 Ensure the manual gas supply shut off valve is in the
manometer is not available, test all connections
by using the supplied leak detection solution.
Open the shutoff valve in the gas supply line
to allow gas to flow through the pipe.
minutes for gas to move through the gas line.
WARNING
flame.
be
installed by a qualified gas technician.
The supply line must be equipped with an approved
manual shutoff valve. This valve should be located in
the same room as the appliance and should be in a
location that allows ease of opening and closing. Do
not block access to the gas shutoff valve.
2 Identify the thread size of the shut off valve.
Flare
Union
Flare
Union
GAS FLOW
Manual
Shutoff
Open
All connections must be wrench-tightened
Flexible
Nipple
OFF position and remove the shipping cap from
the gas pipe at the rear of the appliance.
Limited Warranty
Smart Choice
®
Parts and Accessories
are warranted to be free from defects in
material and workmanship for a period of 90
days from date of purchase. If this product is
found to be defective, return to place of
purchase for
replacement. Smart Choice
®
Parts
& Accessories
shall not be liable for damages or
delays caused
by defects in material or
workmanship, improper installation,
consequential loss, service call costs,
installation or reinstallation
costs, or by failure due to normal wear.
Made In The USA With Globally
Sourced Components
3 Attach the flexible gas line connector to the fitting
female flare nut of the flexible gas supply line onto
4 Identify the threaded connection at the appliance.
a. If the appliance has a 3/8" Male Iron Pipe thread
connection apply sealant to the connection and thread
the 3/8" Female Iron Pipe thread fitting onto the
appliance connection. Wrench tighten.
b. If the appliance has a 1/2" Female Iron Pipe thread
connection apply sealant to the 1/2" Male Iron Pipe fitting
provided with the kit and thread the 1/2" Male Iron Pipe
thread fitting into the appliance connection.
5 Attach the other end of the flexible gas line connector to
the flare fitting installed in step 4 above. Wrench tighten.
a. If the shutoff valve has 1/2" Female Iron Pipe threads
use the supplied 1/2" Male Iron Pipe Thread fitting. Apply
pipe thread sealant to the male iron pipe threads on the
supplied fitting and thread the iron pipe thread into the
shutoff valve. Wrench tighten.
use the supplied 3/4" Male Iron Pipe Thread fitting. Apply
pipe thread sealant to the male iron pipe threads on the
fitting and thread the iron pipe thread into the shutoff