Loading ...
Loading ...
Loading ...
23
Adjusting the Telescoping Pole
This machine is equipped with a telescoping pole which can
telescope from 3.7 ft (1.1 m) to 5.3 ft (1.6 m). To adjust the
telescoping pole, follow the instructions below.
1. Disconnect the hedge trimmer from the power supply by
removing the battery from the compartment.
2. Unclip the telescoping lock to release the pole. Extend the
pole to the desired length (Fig. 40).
NOTE: Push poles toward each other to shorten the pole
or pull them away from each other to lengthen the pole.
Only extend the pole to the minimum length required to
reach the hedges.
3. Lock the pole in position by closing the telescoping lock
(Fig. 41), and ensure that the pole is secured.
mWARNING! Failure to lock the telescoping lock as
directed could result in personal injury.
Adjusting the Multi-Angle Head
The hedge trimmer head can be rotated for 10 dierent cutting
angles for -45º, -30º, -15º, 0º, 15º, 30º, 45º, 60º, 75º, and 90º.
Follow the below instructions to adjust angles.
1. Rotate the trimmer head to the desired cutting angle while
pressing the rotating buttons located on both sides of the
unit simultaneously (Fig. 42).
2. Release the buttons when the trimmer head is xed into
the desired angle.
NOTE: Failure to properly secure the trimmer head may
result in personal injury and/or property damage.
mWARNING! Always ensure the hedge trimmer head is
securely locked! Do not attempt to use the pole hedge trimmer
with the head in any other position or unlocked!
Before Operation
1. Check the tool, the battery as well as accessories for
damage before each use. Do not use the tool if it is
damaged or shows wear.
2. Double check that the accessories and attachments are
properly xed.
3. Always hold the tool by its handle and soft grip. Keep the
handles dry to ensure safe support.
4. Ensure that the air vents are always unobstructed and
clear. Clean them if necessary with a soft brush. Blocked
air vents may lead to overheating and damage the tool.
5. Switch the tool o immediately if you are disturbed
while working by other people entering the working
area. Always let the tool come to a complete stop before
putting it down.
6. Do not overwork yourself. Take regular breaks to ensure
you can concentrate on the work and have full control
over the tool.
Trimming Times
Fig. 40
Pull Pull
Telescoping lock
Fig. 41
Telescoping lock
Fig. 42
Rotating
buttons
Front side Back side
Green leaf hedges June to October
Evergreens April to August
Conifers and other fast
growing shrubs
Every 6 – 8 weeks
Loading ...
Loading ...
Loading ...