Loading ...
Loading ...
Loading ...
12
5. When charging is complete, remove the battery from the
charger by pulling the push lock button and sliding the
battery backward to unlock it from the charger.
6. The iCHRG40 Charger (sold separately) or the
iCHRG40-DPC Dual Port Charger (sold separately) are
also equipped with additional charging indicating lights
which will indicate the charging status (Figs. 3 – 4).
mCAUTION! FIRE HAZARD. When disconnecting the
charger from the battery, be sure to unplug the charger from
the outlet rst, then disconnect the charger from the battery.
mWARNING! The chargers do not automatically turn
o when the battery is fully charged. Please take care not
to leave the battery plugged into the charger. Switch o or
unplug the charger at the mains when charging is complete.
7. Timely recharging of the battery will help prolong the
battery's life. You must recharge the battery pack when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the
battery.
Assembly
m
CAUTION! Do not install the battery before fully
assembling the unit.
mWARNING! Mount the components very carefully so
as not to impair the safety and eciency of the machine. If in
doubt, contact your dealer.
mWARNING! Unpacking and assembly should be
completed on a at and stable surface, with adequate space
for moving the machine and its packaging.
For safety and transportation reasons, the lithium-ion battery
is packed separately from the machine and is partially
charged. Charge the battery before using the tool following the
instructions in the “Charging the battery” section.
Installing/Replacing the Guide Bar
and Chain
mWARNING! Always wear heavy-duty gloves when
handling the bar and chain. Mount the bar and chain very
carefully so as not to impair the safety and eciency of the
machine. If in doubt, contact an authorized Snow Joe
®
+
Sun Joe
®
dealer or call the Snow Joe
®
+ Sun Joe
®
customer
service center at 1-866-SNOWJOE (1-866-766-9563).
mWARNING! When installing/replacing the guide bar and
chain, use only identical replacement parts. Make sure the
battery is not inserted in its housing.
1. Using the supplied hex key wrench, unscrew the end
cover nut and remove the chain/sprocket end cover
(Figs. 5 – 6).
TIP: When replacing the chain, slide on the cutting bar
sheath temporarily for added protection.
Fig. 4
green
red
Charging
green
green
Fully charged
iCHRG40-DPC
LOW
KICKBACK
R
Fig. 5
End cover nut
Hex key wrench
LOW
KICKBACK
Fig. 6
Chain/sprocket
end cover
End cover nut
Loading ...
Loading ...
Loading ...