Loading ...
Loading ...
Loading ...
21
OPERATION
6. Bend one end of the line 1/4 of an inch (0.002 ft.).
Fig. 10-3
7. Insert one line into the anchor hole in the upper part of the spool while the other line into the
anchor hole in the bottom part of the spool.
Fig. 10-4
8. Wind the lines clockwise around the spool simultaneously, as shown by the arrows on the
spool.
Fig. 10-5
9. Place lines in the slot on the upper spool ange, leaving about 6 in. ( 152mm ) extended
beyond the slot.
Fig. 10-6
NOTE: Do not overll. After winding the line, there should be at least 1/4 in. (6mm) between the
wound line and the outside edge of the spool.
10. Place the spool in the trimmer head as shown below.
Fig. 10-7
Loading ...
Loading ...
Loading ...