Loading ...
Binding to the Boiler Relay
The Thermostat is supplied ready to install, binding is
only required if the Thermostat and Boiler Relay are
purchased separately.
2. You can now bind the
Thermostat. Touch and
hold on the left touch
zone for approximately
10 seconds.
3. The screen for binding
the Boiler Relay is
now displayed.
Successful binding Failed binding
1. First, set the Boiler
Relay into binding
mode by holding down
the BIND button for 5
seconds, until the red
LED flashes 0.5 seconds
on 0.5 seconds off.
Press here
4. When the symbol ‘bo’ is flashing, briefly touch
the left touch zone to send the binding signal, at
which point the symbol will flash several times.
5. If binding has been successful the number
indicates the signal strength (1 = min to 5 = max).
If binding fails, appears on
screen. Please try again.
6. The red LED on the Boiler Relay will turn
off when binding has been successful.
Touch zones.
There are two touch zones just below the thermostat
display, which are used to access menus and functions.
10s
Installation Menu
The Thermostat has an Installation Menu that
is used to set the minimum and maximum
temperature limits and the off temperature setting.
Maximum and minimum temperatures:
The maximum temperature you can set your
thermostat to is 35°C and the minimum is 5°C.
The off temperature:
If the thermostat is operated remotely, this
is the temperature value that is used when
it is switched off from the remote app.
4. Touch the left touch zone to
display the off temperature
setting. Change this using
the setting ring as before.
5. The Installation Menu closes
automatically 10 seconds
after the last action.
2. The maximum temperature
limit is now displayed. The
setting can be changed using
the setting ring. There is no
need to confirm the value.
3. While this setting is flashing,
touch the left touch zone
briefly to display the
minimum temperature limit.
This can also be changed
using the setting ring.
1. Rotate the setting ring fully
to the left until the minimum
value is shown. When
the value starts flashing,
touch and hold on both left
and right touch zones for
approximately 10 seconds.
Activate the Installation Menu as follows:
10s 10s
Note: binding can be cancelled from the binding
screen by touching and holding on the left
touch zone for approximately 10 seconds.
Printed in EU.
(EU) 811/2013
© 2020 Resideo Technologies, Inc. All rights reserved.
The Honeywell Home trademark is used under license from Honeywell International Inc.
This product is manufactured by Resideo Technologies, Inc. and its affiliates.
Pittway Sarl, Z.A. La Pièce 4,
1180 Rolle, Switzerland
Country of origin : UK
For support:
Resideo
200 Berkshire Place
Winnersh Triangle, Berkshire
RG41 5R
Phone: 0300 130 1299
Approvals:
Hereby, Pittway Sarl declares that the radio equipment type Y87RF is in
compliance with Directive 2014/53/EU. The full text of the EU declaration of
conformity is available at the following internet address: https://hwllhome.co/DoC
RF (868MHz): Receiver Category 2, Max RF Power 25mW, 868–868.6MHz (868.3MHz)