Loading ...
Loading ...
Loading ...
14
Using the Vacuum/Blower
mWARNING! This equipment incorporates parts such
as switches, motors or the like that tend to produce arcs or
sparks that can cause an explosion. Do not pick up ammable,
combustible, or hot materials. Do not use around explosive
liquids or vapors, as electrical devices produce arcs or sparks
which can cause a re or explosion – do not use at lling
stations or anywhere gasoline is stored or dispensed.
VACUUM MODE
1. Make sure the lter and dust tank are installed before
starting.
2. Make sure the vacuum hose is installed properly and
locked securely in the air inlet (Fig. 7).
3. Install the desired cleaning accessory onto the end of the
hose (Fig. 9).
4. Check that the electrical supply voltage and frequency
(Volt/Hz) correspond to those specied on the rating plate.
If the power supply is correct, you may now plug the
vacuum into the power outlet (Fig. 11).
5. Turn the On/O dial to the VC mark (Fig. 18).
6. During vacuuming, always use the suction hose. Hold the
suction hose at a distance of approximately 0.4 in. (1 cm)
above the material to be vacuumed.
7. When the vacuuming job is done, return the switch to the
OFF(O) position and unplug the power cord. Disassemble
and store all the accessories.
mWARNING! When vacuuming large quantities of liquids,
do not immerse the nozzle attachment completely in the liquid;
leave a gap at the tip of the nozzle opening to allow air inow.
The machine is tted with a oat valve that stops the suction
action when the collection tank reaches its maximum capacity.
You will notice a decrease in motor speed. When this happens,
turn o the machine, unplug the unit, and drain the liquid into a
suitable receptacle or drain.
BLOWER MODE
mWARNING! Keep children and bystanders away from
the working area.
mWARNING! Wear a dust mask if blowing creates dust
that might be inhaled.
1. Make sure the vacuum hose is installed properly and
locked securely in the air outlet (Fig. 8).
2. Install the desired cleaning accessory onto the end of the
hose (Fig. 9).
3. Check that the electrical supply voltage and frequency
(Volt/Hz) correspond to those specied on the rating plate.
If the power supply is correct, you may now plug the unit
into the power outlet (Fig. 11).
4. Turn the On/O dial to the VC mark (Fig. 18).
NOTE: During the whole blowing process, keep the air
inlet clear to maintain stable air ow.
5. After the job is done, turn the On/O dial to the OFF
position, unplug the power cord. Disassemble and store all
the accessories.
Drain the Dust Tank
The dust tank needs to be emptied every time after using to
avoid deterioration and obstructing air ow, which will reduce
the performance of the vacuum. Follow the instructions below
to clean the dust tank.
1. Switch o and unplug the unit.
2. Press the dust tank lock and pull out the dust tank at the
same time (Fig. 19).
3. Grab the dust tank cap and turn it counterclockwise, the
dust tank cap with lter can now be removed from the
dust bin (Fig. 20).
Fig. 18
On/Odial
Fig. 19
Dust tank Dust tank handle
Dust tank lock
Loading ...
Loading ...
Loading ...