Loading ...
SOLAR LIGHT
EN
INSTALLATION DIAGRAM
Fixing
Bracket
Installation Instruction:
1. Drill two holes on the wall after confirming the installation position, then install the
expansion plug into the holes.
2. Put the screw into the expansion plug, do not screw to the end, it is ok if the screw
head is about 2-3mm away from the wall. If the installation surface is wood or soft
material, it can be screwed directly without using the expansion plug.
3. Put the mounting base into two screws on the wall. Then, tighten the base as
shown in Figure 1.
4. Install the lamp on the base, and it can be used.
Switch Function:
- Press and hold the button for 2-3 seconds to switch ON the solar light. Once
switched ON it will indicate a blue light.
- When switching on the solar light by default it will be in Mode 1.
- To enter Mode 2, press the button again.
- Pressing the button for the third time the solar light will switch OFF and the blue
light will disappear.
Operating Modes:
Mode 1: Sensor Mode
- At dusk, it automatically turns to 10% brightness.
- Turns on to 100% brightness when motion is detected in the range of <5 meters
- In 30 seconds if no motion is detected the light switches to 10% brightness.
- Turns off at the dawn.
Mode 2: Constant Brightness Mode
- The sensor will be disabled
- Automatically turns on at the dusk with 100% brightness and works constantly till
the battery capacity goes to Zero. (Upto 4 hours)
Loading ...
Loading ...
Loading ...