Loading ...
19
BEFORE USING THE WASHING MACHINE
1.Remove the packaging and check
• After unpacking, make sure that the washing
machine is undamaged. If in doubt, do not use the
washing machine. Contact After-Sales Service or
your local retailer
• Check that the accessories and supplied parts are
all present
• Keep the packing material (plastic bags,
polystyrene parts, etc.) out of reach of children,
as they are potentially dangerous
2.Remove the transport bolts
• The washing machine is fitted with transport
bolts to avoid any possible damage to the interior
during transport. Before using the washing
machine, it is imperative that the transport bolts
are removed
3.Install the washing machine
• Remove the protective foil from the control
panel
• Move the appliance without lifting it by the
worktop
• Install the appliance on a solid and level floor
surface, preferably in a corner of the room
• Make sure that all four feet are resting firmly on
the floor and check that the appliance is perfectly
level (use a spirit level)
4.Water inlet
• Connect the water supply inlet hose in
accordance with regulations of your local water
company
• Water inlet: Cold water only
• Tap: 3/4” threaded hose connection
• Water Pressure
(flow pressure): 100-1000 kPa (1-10 bar)
5.Drain hose
• Connect the drain hose to the siphon or hook it
over the edge of a sink by means of the “U” bend
supplied
• If the washing machine is connected to a built-in
pumping out system, ensure that the latter is
equipped with a vent to avoid simultaneous loading
and draining of water (siphoning effect)
6.Electrical connections
• Electrical connections must be carried out by a
qualified technician in compliance with the
manufacturer’s instructions and local safety
regulations
• Data concerning voltage, consumption and fuses
are located on the inside of the appliance door
• The appliance must be connected to the mains
exclusively by means of a socket with an earth
connection in accordance with established
regulations. The washing machine must be
earthed by law. The manufacturer declines all
liability for damage to property or injury to
persons or animals due to non-compliance with
the directions given above
• Do not use extension leads or multi sockets
• Before any maintenance on the washing machine
disconnect it from the mains supply
• Access to the mains plug or to disconnection
from mains supply via a double-pole switch must
be ensured at all times following the installation
• Do not operate the washing machine if it has
been damaged during transport. Inform the
After-Sales Service
• Mains cable replacement is only to be carried out
by After-Sales Service
• The washing machine must only be used in the
household for the prescribed uses
Minimum housing dimensions:
Width: 600 mm
Height: 825 mm
Depth: 600 mm
3gb05536.fm Page 19 Tuesday, December 23, 2003 11:50 AM
Black process 45.0° 100.0 LPI
Loading ...
Loading ...
Loading ...