Loading ...
Loading ...
Loading ...
18
Refilling the water tank
• The water tank is empty.
• Switch off then unplug the appliance and open the flap on the tank.
• Fill a jug with untreated tap water then fill the tank up to the max mark.
• Plug in and switch the appliance on again by pressing the on/off switch.
Maintenance and cleaning
Anti calc maintenance
Do not put any descaling substances (vinegar, industrial descaling products, etc.) in the water tank or in the anti calc
cartridge compartment, they could damage your appliance.
To extend the life of your appliance and to avoid scale, your appliance is equipped with a anti calc cartridge system. This
anti calc cartridge system is located below the iron rest.
The cartridge will need to be changed only when the anti-calc indictor flashes which will depend on your frequency of
ironing and how much steam you use.
Operation:
The appliance has an anti calc indicator located on the control panel. When this indicator is flashing it means that
the anti calc cartridge is no longer efficient and must be replaced by a new one.
To replace your anti calc cartridge :
- Never replace the anti calc cartridge during use.
- Switch off and unplug your appliance.
- Wait for at least one hour and check that the appliance is cold.
- Open the anti calc cartridge cover.
- Pull the used anti calc cartridge out of its compartment.
- Be careful, some water drops may fall out of the anti calc cartridge when you remove it from its compartment.
This is normal and the water is harmless.
- Take the new anti calc cartridge out of its bag.
- Place the new anti calc cartridge in the compartment and press it down until it locks.
- Close the anti calc cartridge cover.
- Plug and switch on your appliance. The max indicator located on the control panel flashes while the iron heats
up. When the max indicator light stops flashing and the iron thermostat light goes out (after 2 minutes
approximately), the appliance is ready for use.
- Press the anti calc reset button on the control panel. (3 seconds)
- You might have to press the steam control button for a few minutes to start the steam again as your appliance needs
to re-activate its water circuit when the temperature dial is in the 3 dot position.
This operation is essential to maintain the working life of your appliance.
Using the appliance without changing the cartridge can damage the appliance and stop its steaming
performance. Press on the anti calc button only if you have changed the cartridge.
To ensure the efficiency of the cartridge, please remove it from its plastic bag just before use. The
international guarantee will not cover any damages which occur as a result of using the appliance without
changing the cartridge.
Cleaning your appliance
Before cleaning, ensure your appliance is unplugged and that the soleplate and the iron have cooled down for least
1 hour.
• Do not use detergent or descaling products for cleaning the soleplate base-unit.
• Never hold the iron or the base unit under the tap.
• Regularly clean the soleplate with a damp, non-metallic washing up pad.
• Clean the plastic parts of the appliance occasionally with a soft cloth.
Storing your appliance
• Warning: do not touch the soleplate while still hot.
• Store the water connection cord in its compartment.
• Leave the iron (and the iron rest) to cool down for 1 hour before storing it away.
TE_CENTRALE_FASTEO_1800142429.qxp_110x154 17/10/2016 14:19 Page18
Loading ...
Loading ...