Loading ...
Loading ...
Loading ...
10
ALIGNING THE WALL PLATE
Wear gloves to avoid cutting
fingers on sharp edges.
Draw a vertical line on the wall at the center of the
30″ wide space.
Usethemountingplateas the template for the rear
wall.Placethemountingplateonthewall,making
sure that the tabs are touching the bottom of the
cabinet or the level line drawn in Step C for
cabinets with front overhang. Line up the notch
and centerline on the bottom of the mounting
plate to the centerline on the wall.
While holding the mounting plate with one hand,
draw circles on the wall at holes A, B, C and D
(see illustration above/actual plate marked with
arrows).Four holes must be used for mounting.
NOTE:HolesCandDareinsideareaE.Ifneither
C nor D is in a stud, find a stud somewhere in area
E and draw a fifth circle to line up with the stud. It is
important to use at least one wood screw mounted
firmly in a stud to support the weight of the
microwave.
Set the mounting plate aside.
Risk of electric shock. Can
cause injury or death. Take
care to not drill into electrical wiring inside walls
or cabinets.
Drill holes on the circles. If there is a stud, drill a
3
⁄16″
hole for wood screws. For holes that don’t line up
with a stud, drill a
5
⁄8″ hole for toggle bolts. Drill two
5
⁄8” holes for toggle screws.
NOTE: DO NOT MOUNT THE PLATE AT THIS TIME.
1
2
3
4
Draw a Vertical
LineonWall
from Center of
TopCabinet
Area E
HoleA
HoleB
HoleD
HoleC
D.
Installation Instructions
Centerline
Notches
CAUTION
WARNING
1” = 2.5 cm; 1’ = 0.3 m
Loading ...
Loading ...
Loading ...