Loading ...
Loading ...
Loading ...
OMEGA ALTISE
FILLING THE WATER TANK
Always fill the water tank fully before using the mist function. After use, empty (and clean if necessary) the water tank.
Remove the appliance from the power source. Take the tank out of the rear mounting, unscrew the plug and fill with cool (or
cold) water. Screw the cap securely back onto the tank and fit the tank back into its position at the rear of the misting fan. Make
sure the plug is placed correctly in its mounting, otherwise the water will not flow. Dry any spilled water (and hands) and
reconnect the appliance to the power. The level of the water can be seen through the small water level indicator at the front of
the appliance.
CLEANING & MAINTENANCE
WARNING: ALWAYS UNPLUG THE CORD BEFORE MOVING OR SERVICING, DO NOT
IMMERSE APPLIANCE IN WATER!
The fan should be cleaned periodically (at least once a month depending on the build-up of dust). After unplugging the
appliance, clean the venting, rear guard and fan blades with a damp, soft cloth and then allow to dry.
Clean the body of the misting fan with a soft damp cloth. Always make sure that the appliance is completely dry before
connecting back to the mains supply.
CAUTION: Do not use gasoline, benzene, thinner, harsh cleaners, etc. as they will damage the fan. NEVER use
ALCOHOL OR SOLVENTS.
At least once a week, wash out the tank with clean water. Allow to dry before refilling. Put a few drops of sewing machine
oil between the bearing and motor shaft.
Do not disassemble the fan in any other manner.
STORAGE: Store the misting fan with these instructions, in a cool, dry place.
TROUBLESHOOTING
Fault Possible Cause
Solution
Fan does not work
when plugged in.
Main power off, fuses blown
Check power is on at meter.
Motor failed to start Select a higher fan speed.
Power rating too low Increase power to correct rating.
Fan shaft not turning Knock motor cover to see if it loosens.
PCB or motor capacitor not working
Contact Omega Altise Service.
Excessive shaking
Rear guard loose Tighten rear guard nut.
Blade fastening screw is loose
Tighten blade fastening screw.
Blade damaged Contact Omega Altise Service.
Atomiser working
but no mist coming
out
No water in tan
k
A
dd water to water tank.
W
ater has alkaline solution in it
Clean tank twice & re-try.
W
ater tank is damaged & leaking internall
y
Replace tank & dry other parts.
Mist guide tubes are blocked or incorrectly
fitted
Clean out tubes with water & fit correctly.
Indicator lights on,
fan works, no mist.
No water in tan
k
A
dd water to water tank.
Mist function not selected Select mist function.
The mist smells
New unit
–
plastic smell will go away
Open the tank & leave dry for 12 hours.
W
ater tank dirty or water dirt
y
Change water, clean tank.
Other
Burning smell coming from moto
r
Turn off fan, remove from power & contact
Omega Altise Service.
Insulation damaged Remove from power & contact Omega Altise
Service.
Motor seems to overheat Stop fan for 15 minutes & re-start.
Guards damaged Contact Omega Altise Service, do not use
until replaced.
Loading ...
Loading ...
Loading ...