Loading ...
Loading ...
Loading ...
23
ENGLISH
1. Check the rubber seal in the inlet hose. Two rubber
seals are supplied with each inlet hose. They are used
for preventing water leaks. Make sure the connection
to the cold water tap is tight.
2. Check the installation type.
a.
Shut off the cold water tap and remove the washer hose.
b. Connect the short hose to the Y-connector using one
of the rubber seals.
c. Connect the other end of the short hose to the cold
water faucet.
d.
Connect the long dryer hose to one side of theY-connector
and connect the washer hose to the other side.
a. Connect the straight end of the long hose to the cold
water faucet.
Connecting the Inlet Hose
The dryer must be connected to the cold water tap using the new water supply hose. Do not reuse old hoses.
3. Connect the hose to the dryer.
• Connect the water supply hose to the dryer inlet valve
tightly by hand and then tighten another 2/3 turn with
pliers.
Make sure that there are no kinks in the hoses and that
they are not crushed.
4. Turn on the cold water faucet.
5. Check for leaks at the Y-connector (if used) and in all
hoses.
NOTE
• If any leaks are found, shut o the water faucet,
remove the hose and check the condition of the
rubber seals.
NOTE
• Before connecting the water line to the dryer, ush
several gallons of water into a drain or bucket. This will
help prevent foreign particles such as sand and scale
from clogging the dryer inlet valve.
• Do not overtighten. Damage to the coupling can result.
NOTE
• Water supply pressure must be between 20 psi and 120 psi (138–827 kPa).
• Do not strip or cross-thread when connecting the inlet hose to the valve.
• If the water supply pressure is more than 120 psi (827 kPa), a pressure reducing valve must be installed.
• Periodically check the condition of the hose and replace the hose if necessary.
• Replace inlet hoses after ve years of use to reduce the risk of hose failure.
• Record hose installation or replacement dates on the hoses for future reference.
Hose
connector
Y connector
Rubber
seal
Long
hose
WITH WASHER WITHOUT WASHER
Short
hose
Y connector
INSTALLATION
MFL67731067_en_160511.indd 23 2016.5.11 10:50:35 AM
Loading ...
Loading ...
Loading ...