Loading ...
Loading ...
Loading ...
Minimum
cutout height
110
2
5
30
remove all the way up
Wheel
position
Number of turns
on front leg
Perforation
on blanket
remove
keep
keep
keep
33³⁄₄" (85.7 cm)
33⁷⁄₈" (86 cm)
34" (86.4 cm)
34¹⁄₄" (87 cm)
34¹⁄₂" (87.6 cm)
remove
all the way up
keep
Dishwasher Height Adjustment Chart
Built-up floors: If the kitchen floor is higher than the
cabinet opening's floor - for example, the kitchen floor tile
does not extend into the cabinet opening - add shims as
needed in the area shown to bring the dishwasher up to
34
" (86.4 cm) below the countertop.
NOTE: Shims must be securely attached to floor to avoid
movement when the dishwasher is in use.
(7 cm
)
4
"
(10.1 cm
)
2
"
(5 cm
)
Built-up Floors—Add
shims as needed
3
14
Install door handle
Mounting stud
Handle
Setscrew
(in bottom
of handle)
Hex key
Install the Door Handle
(on some models)
Custom Panel Dimensions
*
Custom panel dimensions—Dishwashers
with control panel on the top
This dimension is for 4" (10.2 cm) toe kick. If the
installation needs a higher toe kick, adjust the height
of the wood panel accordingly. Not recommended for
toe kicks greater than 6" (15.2 cm).
*
23⁵⁄₈"
(60 cm)
*29²⁹⁄₃₂" (76 cm)
Turn both leveler legs to the same height. Put wheels in
the required position determined from “Dishwasher
Height Adjustment Chart.”
Adjust wheels and legs
2
1
2
3
Wheel
NOTE: If the minimum cabinet opening height is less than
34" (86.4 cm), the rear wheels can be removed for
additional clearance. This will allow the dishwasher to fit
into a 33⁷⁄₈" (86 cm) high cabinet opening, but the
dishwasher will be more difficult to move. (Measurements
are approximate. Wheels and legs are preset at the
factory for 34¹⁄₂" [87.6 cm].) If the minimum cabinet
opening height is 33³⁄₄" (85.7 cm), a section in the
insulation blanket can be removed by cutting along the
perforation.
IMPORTANT: Do not scratch the front panel during this
procedure.
Remove the door handle and hardware bag containing the
setscrews and hex key from the cardboard box. Setscrews
are already installed in the handle. Place handle on
mounting studs with the setscrews facing down. Push the
door handle tightly against the door. Insert the short end
of the hex key into the setscrews. Tighten the setscrews ¹⁄₄
turn past snug.
Retain hex key with Installation Instructions.
Cut insulation blanket along perforation
Loading ...
Loading ...
Loading ...