Loading ...
Loading ...
Loading ...
EN
5
Recirculation mode:
Leave the motor intake free. Install the active
carbon filters as shown in page 7.
Warning: if the hood is not supplied with an active
carbon filter, it is necessary to buy it separately
and assemble it before using the hood.
m) Chimney assembly:
Adjust the two telescopic chimneys to the required
length (fig. 6).
Block the chimneys by tightening the two H
screws .
Place the chimneys group on the top side of the
hood carefully. Put the chimney bracket K on the
B chimney (fig. 6). Mark the holes on the wall for
fixing the chimney bracket to the wall.
Remove the chimney set, drill and fix the support
racket to the wall by means of wall anchors. . Put
the chimney group back in place and fix it to the
hood with the Z screws and to the chimney
bracket with the L screws as shown in figure 6.
ELECTRICAL CONNECTION
It is recommended that all electrical connection
operations are performed by a qualified
technician.
The appliance is supplied WITHOUT A PLUG. It is
therefore necessary to fix a plug to the wire. The
plug and fuse must be in accordance with the
rating plate inside the hood. Then connect it to a
nearby, easily reachable socket in accordance
with the rules in force.
In the case of a direct connection to the mains
supply, it is necessary to put a switched spur
between the appliance and the mains supply. The
switch must be suitable for the load, compliant
with the rules in force and must have a minimum
contact opening of not less than 3mm.
Loading ...
Loading ...
Loading ...