Loading ...
Loading ...
Loading ...
3. Screwoncouplingbyhanduntilitisseatedonthewasher.
C
4.
Using pliers, tighten the couplings with an additional
two-thirds turn.
NOTE: Do not overtighten or use tape or sealants on the
valve. Damage to the valves can result.
5=
6.
7.
Attach the cold water hose to the top inlet valve.
Screw on coupling by hand until it is seated on the washer.
Using pliers, tighten the couplings with an additional
two-thirds turn.
NOTE: Do not overtighten or use tape or sealants on the
valve. Damage to the valves can result.
Check for leaks
• Turn on the water faucets and check for leaks. A small
amount of water might enter the washer. You will drain this
later.
NOTE: Replace inlet hoses after 5 years of use to reduce the
risk of hose failure. Record hose installation or replacement
dates for future reference.
• Ifyou connect only one water hose, you must cap off the
remaining water inlet port.
• Periodically inspect and replace hoses if bulges, kinks,
cuts, wear, or leaks are found.
1=
2.
Remove the shipping strap from the power cord. Drape the
power cord over the console.
Remove any cardboard used to move washer.
(2>
Beaded tie strap
3. Wrap the drain hose to the laundry tub leg or drain standpipe
with the beaded tie strap. Push fastener into the nearest hole
in the beaded tie strap. See view A or B.
B C
If the washer faucets and the drain standpipe are recessed,
put the formed end of the drain hose into the standpipe.
Tightly wrap the tie strap around the water inlet hoses and the
drain hose. See view C.
Properly leveling your washer prevents excessive noise and
vibration.
Install the Front Leveling Feet
1. Prop up the front of the washer about 4" (10.2 cm) with a
wood block or similar object. The block needs to support the
weight of the washer.
A
Screw the Iocknut onto each foot to within 1" (2.5 cm) of the
foot base.
(2.5cm)
f
Loading ...
Loading ...
Loading ...