Loading ...
Loading ...
Loading ...
12
5. Locate and remove the blue pump outlet
clip from the drainage outlet on the
opposite side of the dehumidifier, and set
aside for later use. Insert one end of the
8m pump drainage hose into the pump
drainage outlet, ensuring the hose is pushed
in as far as possible.
Remove the blue
pump outlet clip
NOTE
Keep the blue outlet pump clip in a safe place
for future use if the pump drainage is no
longer required.
NOTE
If the 8m hose is too long, it can be cut to the
desired length.
6. Place the other end of the drainage hose
into a drainage source such as a bathroom
floor drain or laundry sink.
7. Press the
PUMP button to start pump
drainage and the PUMP ON light will
illuminate on the control panel. The pump
will enter standby mode and will only drain
once the water tank is full. The pump will
stop draining after 15 minutes. This cycle
will continue each time the tank is full.
NOTE
If at any time the pump needs to be activated
manually during dehumidification, press and
hold the
PUMP button for 5 seconds and
the pump will automatically begin and run for
8 minutes, then turn off.
8. If pump drainage is no longer required,
hold the PUMP button down until
the PUMP ON light is off. Ensure the
dehumidifier is switched off and unplug
from the power outlet.
9. Remove the drainage hose from the rear of
the unit.
10. Replace the blue pump outlet clip, placing
it between the ring and base of the
pump outlet.
DEFROST
This dehumidifier is equipped with an
automatic defrost function. The evaporator
may start auto-defrosting if operating in a
room temperature that is less than 23°C.
1. If the
DEFROST light turns on,
defrosting has automatically started. The
fan will operate on HIGH during defrost
and dehumidification will stop.
2. Automatic defrost will operate for up to
5 minutes.
WARNING
Do not disconnect the plug or turn
off the unit during defrost operation.
LAD500_ANZ_IB_C19.indd 12 8/4/19 1:38 pm
Loading ...
Loading ...
Loading ...