Loading ...
Loading ...
Loading ...
6
the hours left before the appliance comes on. Change the hours
using the + and - buttons, then wait a few seconds for the
program to be stored. The display will return to o and the
symbols remains on. When the programmed time has elapsed,
the appliance will come on with the previous settings.
Delayed stop: with the appliance on, press the timer button
. The symbol is displayed ashing together with the
hours left before the appliance goes on-standby. Change the
hours using the + and - buttons, then wait a few seconds for
the program to be stored. The current settings and symbol
are displayed. At the end of the set time the appliance switches
on-standby automatically. To go back to operating without the
timer, press the timer button twice.
The timer symbol disappears from the display.
Please note: the time is settable from 0.5 to 24 hours.
Changing of the temperature scale
The display can show the temperature in both °F (Fahrenheit)
and °C (Celsius). To select the desired temperature scale, when
the unit is in standby position, press and hold the "+" key for at
least 10 seconds, then release.
The change of scale will be indicated by two short beeps.
MAINTENANCE
Before carrying out any maintenance, unplug the heater from
the mains and wait for it to cool o completely.
This heater requires no particular maintenance. It is sucient
to remove the dust with a soft, dry cloth. Never use abrasive
powders or solvents. If necessary remove concentrated areas
of dirt with a vacuum cleaner. Please refer to the enclosed
guarantee leaet for service and assistance details.
TECHNICAL CHARACTERISTICS
Supply voltage See rating label
Absorbed power “
PROBLEM CAUSE SOLUTION
The appliance doesn't work Be sure it is plugged in and that the electrical
outlet is working
The temperature may be set too low
The Key lock may be activated
The timer is not correctly programmed
Plug into the power outlet
Set the temperature higher
See the section "Key lock"
Program the timer correctly
The display shows a
blinking dot and you hear an
intermittend "beep"
The appliance could have been tipped over or
is positioned in an improper way
Make sure the appliance is standing upright on a
at surface. Position the appliance correctly
The display shows "P.F"
The temperature sensor is malfunctioning
Contact De'Longhi Customer Experience
The display shows "H.t"
blincking (the appliance
switch o)
The internal temperature is too high
Unplug from the mains. Let the appliance cool
down
Check the
air intake or outlet grille
are not
obstructed and the appliance is correctly
positioned respecting the minum distances from
the wall, or other objects, as indicated in Fig. 2
After few minutes plug in the appliance again,
the unit goes always to stand-by
TROUBLESHOOTING