Loading ...
Loading ...
Loading ...
Electrical Connections
Electrical Requirements
120-volt, 60 Hertz, properly grounded branch
circuit protected by a 15-amp or 20-amp circuit
breaker or time delay fuse.
Extension Cord Cautions
Because of potential safety hazards associated
with certain conditions, we strongly recommend
against the use of an extension cord. However,
if you still elect to use an extension cord, it is
absolutely necessary that it be a UL-listed,
3-wire grounding-type appliance extension cord
and that the current carrying rating of the cord
in amperes be equivalent to, or greater than,
the branch circuit rating.
Grounding
IMPORTANT—(Please read carefully)
FOR PERSONAL SAFETY, THIS APPLIANCE
MUST BE PROPERLY GROUNDED.
The power cord of this appliance is equipped with
a three-prong (grounding) plug which mates with a
standard three-prong grounding wall receptacle to
minimize the possibility of electric shock hazard
from this appliance.
The customer should have the wall receptacle and
circuit checked by a qualified electrician to make
sure the receptacle is properly grounded.
Where a standard two-prong wall receptacle is
encountered, it is the personal responsibility and
obligation of the customer to have it replaced with
a properly grounded three-prong wall receptacle.
DO NOT, UNDER ANY CIRCUMSTANCES,
CUT OR REMOVE THE THIRD (GROUND)
PRONG FROM THE POWER CORD.
A word about GFCI’s – GFCI’s are not required or
recommended for gas range receptacles.
Ground Fault Circuit Interrupters (GFCI’s) are
devices that sense leakage of current in a circuit
and automatically switch off power when a
threshold leakage level is detected. These devices
must be manually reset by the consumer. The
National Electrical Code requires the use of GFCI’s
in kitchen receptacles installed to serve countertop
surfaces. Performance of the range will not be
affected if operated on a GFCI-protected circuit but
occasional nuisance tripping of the GFCI breaker
is possible.
Usage Situations where Appliance
Power Cord will be Disconnected
Infrequently.
An adapter may be used only on a 15-amp circuit.
Do not use an adapter on a 20-amp circuit. Where
local codes permit, a
TEMPORARY CONNECTION
may be made to a properly grounded two-prong
wall receptacle by the use of a UL-listed adapter,
available at most hardware stores. The larger slot in
the adapter must be aligned with the larger slot in
the wall receptacle to provide proper polarity in the
connection of the power cord.
When disconnecting the power cord from the
adapter, always hold the adapter with one hand.
If this is not done, the adapter ground terminal is
very likely to break with repeated use. Should this
happen,
DO NOT USE
the appliance until a proper
ground has again been established.
CAUTION:
Attaching the adapter
ground terminal to the wall receptacle cover
screw does not ground the appliance unless the
cover screw is metal, and not insulated, and the
wall receptacle is grounded through the house
wiring. The customer should have the circuit
checked by a qualified electrician to make sure
the receptacle is properly grounded.
Preferred Method
Temporary Method
Ensure proper ground exists
before use
Ensure proper ground
and firm connection
before use
(Adapter plugs not permitted in Canada)
Align large prongs/slots
Read these instructions completely and carefully.
Operating Instructions
48
Safety InstructionsInstallation InstructionsTroubleshooting TipsConsumer Support
Installation of the range.
Loading ...
Loading ...
Loading ...