Loading ...
Loading ...
Loading ...
5
SHOT OF STEAM
1. Check that the temperature control is at S or higher.
2. Lift the iron off the fabric.
3. Press the P button.
4. Leave 4 seconds between shots to let the temperature build up.
DRY IRONING
1. If you’re going to be dry ironing for 20 minutes or more, empty the reservoir first, to avoid
spontaneous bursts of steam.
2. Set the steam control to S.
3. Set the desired temperature.
4. Wait till the light goes out, then start ironing.
VERTICAL STEAMING
Remove wrinkles from hanging clothes, hanging curtains, and furnishing fabrics.
• Check that there’s adequate ventilation behind the fabric, otherwise moisture may build up,
causing mildew.
• Check that there’s nothing behind the fabric that may be damaged by the steam.
• Check that pockets, turn-ups, and cuffs are empty.
• Check that there’s water in the reservoir.
1. Set the temperature control to max, set the steam control to S.
2. Hold the iron close to (but not touching) the fabric.
3. Press the P button (you’re using the “shot of steam” function vertically).
4. Leave 4 seconds between shots, to let the temperature build up.
SELF CLEAN
To avoid scale build up, use the self clean function at least monthly in normal water areas, more
often in hard water areas.
You’ll need a basin or a large bowl to catch the water coming out of the soleplate.
1. Fill the reservoir to the max mark.
2. Set the temperature control to max, set the steam control to S.
3. Sit the iron on its heel.
4. Put the plug into the power socket, and wait till the light goes out.
5. Hold the iron over the basin or bowl, with the soleplate down.
6. Press the C, and hold it down.
7. Gently move the iron to and fro, over the basin or bowl.
8. Water and steam will wash scale and dust through the soleplate, and into the sink.
9. When the reservoir is empty, release the C button.
10. Unplug the iron, and sit it on its heel to cool.
11. Follow the steps under AFTER USE.
AFTER USE AND STORING
CAUTION: Allow the iron to fully cool before storing.
1. Set the temperature control to • and set the steam control to S.
2. Unplug the iron.
3. Open the water inlet cover.
4. Hold the iron over a sink, turn it upside down, and drain the water from the reservoir.
Loading ...
Loading ...
Loading ...