Loading ...
Loading ...
Loading ...
6
Electrical Requirements
If codes permit and a separate ground wire is used, it is
recommended that a qualied electrical installer determine
thatthe ground path and the wire gauge are in accordance
withlocal codes.
Check with a qualied electrical installer if you are not
suretheoven is properly grounded.
This oven must be connected to a grounded metal,
permanentwiring system.
Be sure that the electrical connection and wire size are
adequateand in conformance with the National Electrical
Code,ANSI/NFPA 70 — latest edition or CSA Standards C22.
1-94, Canadian Electrical Code, Part 1 and C22.2 No.
O-M91 — latest edition, and all local codes and ordinances.
A copy of the above code standards can be obtained from:
National Fire Protection Association
1 Batterymarch Park
Quincy, MA 02169-7471
CSA International
8501 East Pleasant Valley Road
Cleveland, OH 44131-5575
Electrical Connection
To properly install your oven, you must determine the type
ofelectrical connection you will be using and follow the
instructions provided for it here.
■ Oven must be connected to the proper electrical voltage and
frequency as specied on the model/serial/rating plate. The
model/serial/rating plate is located under the control panel
on single ovens and under the control panel on the upper
oven cavity on double ovens. See the following illustrations.
A
A
Single Oven
A. Model/serial/rating plate
Double Oven
A. Model/serial/rating plate
■ Models rated from 7.3 to 9.6 kW at 240 volts (5.4 to 7.4kW
at 208 volts) require a separate 40-amp circuit. Models
ratedat 4.8 kW and below at 240 volts (3.6 kW and below
at208 volts) require a separate 20-amp circuit.
■ A circuit breaker is recommended.
■ Connect directly to the circuit breaker box (or fused
disconnect) through exible, armored, or nonmetallic
sheathed, copper cable (with grounding wire). See the
“MakeElectrical Connection” section.
■ Flexible conduit from the oven should be connected
directlyto the junction box.
■ Fuse both sides of the line.
■ Do not cut the conduit. The length of conduit provided
isforserviceability of the oven.
■ A UL Listed or CSA Approved conduit connector
mustbeprovided.
■ If the house has aluminum wiring, follow the
procedurebelow:
Connect the aluminum wiring using special connectors
and/or tools designed and UL listed for joining copper to
aluminum.
Follow the electrical connector manufacturer’s recommended
procedure. Aluminum/copper connection must conform with
local codes and industry accepted wiring practices.
Voltage Single Double
240 VAC 5.8 kW 9.6 kW
208 VAC 4.4 kW 7.7 kW
Loading ...
Loading ...
Loading ...