Loading ...
Loading ...
Loading ...
15
48-, 78-, 115-Can Beer and Beverage Cooler
www.insigniaproducts.com
Troubleshooting
Fault indication
If a fault is detected, the display shows one of the following codes:
Caution
Do not try to repair your beer and beverage cooler yourself.
Doing so invalidates the warranty.
Fault code E1 E2
Description Temperature sensor fault Defroster sensor fault
Note
When the above faults are displayed, do not attempt to repair
the cooler by yourself. Please contact customer service for help.
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
The beer and beverage
cooler does not operate
The beer and beverage cooler
is unplugged.
Make sure that the beer and beverage cooler is plugged in and
that the plug is pushed completely into the outlet.
The fuse on the circuit is blown
or the circuit breaker is
tripped.
Check the house fuse/circuit breaker box and replace the fuse or
reset the circuit breaker.
Power failure. If a power failure occurs, the beer and beverage cooler turns off.
Wait until the power is restored, then turn it on again.
The cooler door does
not close completely
The shelf is out of position. Adjust the shelf properly.
The door gaskets are dirty. Clean the door gaskets.
The cooler is not level. Level the cooler with the leveling feet.
The cooler is not cold
enough
The door has been opened too
often or was not closed
properly.
Make sure that the door is closed properly.
You have just added a large
amount of warm beverage to
the cooler.
Allow time for the new beverage to cool, then check again.
The temperature control is set
too warm.
Set the control to a colder setting.
Loading ...
Loading ...
Loading ...