Loading ...
Loading ...
Loading ...
English 37
Installation
NOTE
Make sure to secure a 41 mm (A: for both
the sliding hinge and the xed hinge) gap
between the refrigerator and the closet or
alcove. Then, x the front legs using the
screws.
A A
A
A
STEP 5 Initial settings
By completing the following steps, the refrigerator should be fully functioning.
1. Remove the PE foam sheet on each shelf corner, which is attached to protect the
refrigerator during transportation.
2. Open the door, and check if the interior light lights up.
3. Remove the PE foam on the magnet
from the top of the door.
4. Set the temperature to the coldest, and wait for about an hour. Then, the freezer will be
slightly chilled, and the motor will run smoothly.
5. Wait until the refrigerator reaches the set temperature. Now the refrigerator is ready
for use.
NOTE
When the refrigerator powers on, the alarm will sound. To turn off the alarm, press Freezer
or Fridge.
Untitled-6 37 2017-11-14 4:48:35
Loading ...
Loading ...
Loading ...