Loading ...
Loading ...
Loading ...
N80CB TOOL SPECIFICATIONS
TOOL AIR FITTING:
This tool uses a 1/4 N.P.T. male plug. The inside diameter should be .275” (7mm) or larger.
The fitting must be capable of discharging tool air pressure when disconnected from the air
supply. The connector socket on the air hose should be .275” (7mm) inside diameter or larger.
OPERATING PRESSURE:
70 to 100 p.s.i.g. (4.9 to 7.0 kg/cm
2
). Select the operating pressure within this range for best
fastener performance.
DO NOT EXCEED THIS RECOMMENDED OPERATING PRESSURE.
AIR CONSUMPTION:
The N80CB requires 7.2 cubic feet per minute of free air to operate at the rate of 100 nails per
minute, at 80 p.s.i.g. (5.6 kg/cm
2
). Take the actual rate at which the tool will be run to
determine the amount of air required. For instance, if your fastener usage averages 50 nails
per minute, you need 50% of the 7.8 c.f.m. which is required for running at 100 nails per minute.
BOSTITCH OFFERS TWO TYPES OF OPERATION FOR THIS SERIES TOOL
CONTACT TRIP
The common operating procedure on “Contact Trip” tools is for the operator to contact the work
to actuate the trip mechanism while keeping the trigger pulled, thus driving a fastener each
time the work is contacted. This will allow rapid fastener placement on many jobs, such as
sheathing, decking and pallet assembly.
All pneumatic tools are subject to recoil when driving fasteners. The tool may bounce,
releasing the trip, and if unintentionally allowed to recontact the work surface with the trigger
still actuated (finger still holding trigger pulled) an unwanted second fastener will be driven.
SEQUENTIAL TRIP
The Sequential Trip requires the operator to hold the tool against the work before pulling the
trigger. This makes accurate fastener placement easier, for instance on framing, toe nailing
and crating applications.
The Sequential Trip allows exact fastener location without the possibility of driving a second
fastener on recoil, as described under “Contact Trip”.
The Sequential Trip Tool has a positive safety advantage because it will not accidentally drive a
fastener if the tool is contacted against the work – or anything else – while the operator is
holding the trigger pulled.
MODEL IDENTIFICATION:
Refer to Operation Instructions on page 4 before proceeding to use this tool.
CONTACT TRIP SEQUENTIAL TRIP
Identified by: Identified by:
BLACK TRIGGER GRAY TRIGGER
OPERATION
-4-
All screws and nuts are metric.
TOOL
MODEL ACTUATION LENGTH HEIGHT WIDTH WEIGHT
N80CB-1 Contact Trip 12-1/16” (306mm) 13-1/4” (336mm) 5-9/16” (140mm) 8lb. 8oz. (3.86kgs.)
N80CB-2 Sequential Trip 12-1/16” (306mm) 13-1/4” (336mm) 5-9/16” (140mm) 8lb. 8oz. (3.86kgs.)
Loading ...
Loading ...
Loading ...