Loading ...
Loading ...
Loading ...
-11-
ACCESSORIES AVAILABLE:
N80CB DRIVER MAINTENANCE INSTRUCTIONS
Worn driver causing poor quality or loss of power:
• Wear on the driving tip will affect the nail drive, giving symptoms of bent and incompletely driven
nails, and damaged nail heads.
• The driver length may be adjusted to allow the driving tip to be redressed to compensate for
wear. Heat and precise measurement are required. Contact a qualified service technician for
this adjustment.
• The length setting for a new driver is shown below. Measurement is from the bottom face of the
main piston.
• Note that the measurement from the top of the piston gives the maximum amount the driver
may be adjusted to allow redressing. Always extend the driver the minimum required to allow
redressing to restore the driving end; several redressings will be possible before this maximum
depth is reached.
Loosen screw as shown. Adjust to desired exhaust direction and tighten screw.
3/8" (9.5mm) maximum limit of driver recessed
into piston. Do not exceed this limit
NOTE: WHEN DRESSING IS REQUIRED, USE
.015" - .025 x 45˚ CHAMFER
(.38 - .64mm x 45˚ CHAMFER)
SEE NOTE
6.000" – 6.020"
Standard Length N80CB/N80P
(152.4mm – 152.9mm)
NOTE: Driver wear of approximately 1/8” (3mm) can be tolerated in most applications.
However, in difficult driving applications, driver wear or approximately 1/16” (1.5mm) may
cause a slight reduction in the apparent driving power.
NOTE: For “Flush-Driving”, length settings shorter than shown above may be used.
However, the adjusted length should never be less than 5.705” (144.9mm), or more than
6.055” (153.8mm), otherwise normal nailer function may be adversely affected.
BC601 4 oz. Bostitch Air-Tool Lubricant
BC602 1 pint Bostitch Air-Tool Lubricant
BC603 1 pint Bostitch “Winter-Formula” Air-Tool Lubricant
BC604 1 quart Bostitch Air-Tool Lubricant
100679 Lube 1 lb. can
SEQ1 Sequential Trip Conversion Kit
N80K2 Remote Control Kit
N80CK1 Smooth Trip Kit
N80CK2 Dial-A-Depth
TM
Fastener Control Kit
ORK11 O-Ring Kit
BK3 Bumper Kit
N80154A Replacement Driver Assembly - A “Hard Driver” for high volume applications, such as
pallets
851325 Loctite 271 (.02 oz.)
831385 Loctite 242 (.02 oz.)
105005 Assembly, Adjustable Contact Trip
6.000” - 6.020”
Standard Length N80CB/N80P
(152.4mm - 152.9mm)
DIRECTIONAL EXHAUST DEFLECTOR