Loading ...
Loading ...
Loading ...
Setting the signal and current en
29
M Setting the signal and
current
Setting the signal and current
You can change the following settings:
■ The spin speed that is used for
spinning your laundry before it is
dried,
■ The volume of the audible signal at
the end of the programme,
■ The volume of the audible button
signals,
■ The current rating for your dryer's
fuse (10 A or 16 A).
Note: The values for the energy
label are determined using a circuit
breaker/fuse rating of 16 A. If the
circuit breaker/fuse rating is
changed to 10 A, the drying time
and energy consumption will be
higher. You can find details on this in
the consumption values table.
~ Page 35
You must activate the setting mode in
order to change these settings.
Activating setting mode
1. Switch the dryer on.
2. Select the "Cottons" programme in
position 1 and wait for five seconds.
Setting mode is now activated. The
symbols go out in the display panel and
the programme duration is displayed.
1. Press and hold the Start button and,
at the same time, turn the
programme selector clockwise to
position 2.
2. The spin speed is shown in the
display.
3. Press the "Ready in" time button or
the drying time button to change the
spin speed.
4. Turn the programme selector
clockwise to position 3.
5. The volume of the audible signal at
the end of the programme is shown
in the display.
0 = off, 1 = quiet, 2 = medium,
3 = loud, 4 = very loud
6. Press the "Ready in" time button or
the drying time button to change the
volume.
7. Turn the programme selector
clockwise to position 4.
8. The volume for the audible button
signal is shown in the display.
0 = off, 1 = quiet, 2 = medium,
3 = loud, 4 = very loud
9. Press the "Ready in" time button or
the drying time button to change the
volume.
10.Turn the programme selector
clockwise to position 5.
11.The current is shown in the display.
LO = 10 A
HI = 16 A
12.Press the "Ready in" time button or
the drying time button to change the
current.
Exiting setting mode
Turn the programme selector to the
"Off" position once you have set the
required spin speed, volume or fuse
current rating. The settings have now
been saved.
Loading ...
Loading ...
Loading ...